![](/images/new-backgrounds/1193046/19304651x1.webp)
Installation | Section 2 |
|
|
9Using a screwdriver, turn each screw until part of it protrudes from the wall, as shown:
!There must be 4.0 mm (.16 inches) between the wall and the underside of the screw head.
!The maximum distance from the wall to the top of the screw head is 7.6 mm (.3 in).
7.6mm (.3 inches) maximum
10.5mm (.4 inches) maximum
4.0 mm
10Remove the front two plastic feet, nearest to the LED panel, from the bottom of the WE800G to uncover the keyholes.
11Place the WE800G so the keyholes are above the mounting screws.
12Slide the Wireless Ethernet Bridge down until it stops against the top of the keyhole opening.
13Follow the procedures in “Electrical Connection to Wireless Ethernet Bridge” located later in this section to connect the WE800G.
WE800G |