Channel Banks Overview
Channel Banks Note: Disable all Aux sources in the Installer Menu that will not be made available to the end user.
Channel banks enable institution administrators to control access to patient
CHANNEL PREVIEW - BANK 1
CH |
Enter
CC
Channel Banks Setup Menu
Channels Available Charts
All channels found in the channel search are included in each of the chan- nel banks. The default is for all channels to be active in Channel Banks 1, 2, 3, and 4. Create channel banks charts similar to the examples on the following pages. On the channel bank charts, show the status for each channel in all channel banks. This then becomes the patient entertainment programming offerings plan.
Setting Up Channel Banks
The LG Installer Remote is required to access the Channel Banks Setup Menu (see example above at right) and administer channel banks. Refer to “Channel Banks Setup” on the following pages for detailed information on using the Installer Remote to setup and administer channel banks.
Before you begin to set up channel banks, note the following:
•Complete either the Commercial Mode Setup procedure or run the Ex- press Script Installer Menu Wizard (see pages 14 to 15 or pages 16 to 17, respectively). Channel banks can only be set up after the TV setup has been transferred to the internal TV controller (PTC).
•Installer Menu item 028 CH. OVERIDE must be set to 001 to allow access for channel banks setup.
MUTE POWER
CH
BANK PREVIEW GUIDE
SAP INFO CC
| CH |
VOL | OK |
VOL | |
| CH |
FLASHBK
TIMER MENU ALARM
ADJ
ADJ ADJ ADJ
BED1 BED2
Note: The default setting for Aux sources is to be active in the Installer Menu. The Aux sources will appear between the highest analog and lowest digital channel number in the channel scan with Channel Up/Down. If the Aux sources will not be used, it is advisable to set them to 000 (Off) before running
Use the Installer Remote to access the Channel Banks Setup Menu.
26 |