LG Electronics 32LG3DCH, 32LG3DDH Clone Programmer Troubleshooting, Troubleshooting Cont, Symptom

Troubleshooting (Cont.)

Clone Programmer Troubleshooting

Warning: Do not connect a clone programmer to a PPV card installed in the Master or Target TVs, as this will damage the clone programmer and the PPV card.

Reset Clone Programmer After Static Shock

After replacing exhausted batteries (LT2002 only), or if the clone programmer behaves strangely after a static shock:

•TLL-1100A: Turn the TLL-1100A OFF and then ON.

•LT2002: Use a paper clip or similar instrument inserted through the small hole marked RESET to activate the internal reset switch and restore normal operation.

After a reset, check the real-time clock setting. It may be necessary to reset the clone programmer clock from a TV containing the correct time.

Notes

•The TLL-1100A and LT2002 clone programmers are designed to be used with TVs containing the 221-01006 and later pro- cessors. Use with earlier TVs may give unpredictable results. Processors used before the 221-01006-04 have a limited screen display capability; they cannot display entire screens as shown in the setup instructions accompanying the clone programmer. Use the printed menu illustrations in the docu- mentation as an aid to making your programming choices.

•Both Master and Target TVs must be in Pass-through Mode for cloning purposes. See also IMPORTANT CLONING INFORMATION on page 30.

Symptom	Possible Cause(s)	Possible Solution(s)
Clone Programmer
Clone copies setup in less	Not enough time to copy entire	TLL-1100A: Turn the TLL-1100A Off and then ON.
than 30 seconds.	TV setup.	LT2002: Press RESET on clone programmer.
		Then redo Learn/Teach. (Learning usually takes about 90 seconds;
		Teaching usually takes 3 to 4 minutes.)
Remote does not operate	Wrong Installer Remote.	Only use an LG Installer Remote to operate clone programmer
clone programmer.		with TV.
Clone menu does not dis-	MPI cord not connected.	Connect MPI cord properly, and ensure good connection.
play on TV screen, TLL-
	TV not turned ON.	TV must be powered ON for clone programmer to work.
1100A shows error mes-
	(LT2002 only) Weak batteries.	Install four (4) fresh AA high-quality alkaline batteries.
sage, or LT2002 LED does
not blink.	(TLL-1100A only) No charge.	Ensure the TLL-1100A is fully charged or connected to AC power.
Clone menu hard to read.	Weak signal.	Connect TV to a reliable analog channel signal source.
No time set.	Time not available.	Set time on a TV, and copy time to clone programmer.
Clone not working.	Clone programmer problem.	• Try a different clone programmer.
		• Reset the clone programmer.
Clone scans channels	Clone should only scan channels	Ensure TV is set up correctly, and try cloning again.
more than once.	once.
Master and Target TVs
Cloning did not work.	Procedure interrupted.	Wait until procedure complete message is displayed.
	Different TV models.	Cloning is only possible with identical model TVs.
	Step(s) omitted or not per-	Refer to the applicable cloning procedure(s), and make sure all
	formed.	tasks were performed.
(LT2002 only) Clone time	Batteries were removed.	Batteries must remain installed to retain time settings.
disappeared.
New setup not present.	Target TV not reset.	Disconnect Target TV from AC power for fifteen (15) seconds.

•After cloning operations are complete, unplug the TLL-1100A/LT2002 from the TV.

•If the TV does not display a picture (blank screen) after a few seconds, just change channels.

206-4096 43