Pillow Speaker Setup
Set up pillow speaker after Commercial Mode Setup and Cloning procedures are complete.
Connect a Pillow Speaker to the LCD TV/Monitor
1.Connect the Pillow Speaker to the output jack on the back of the TV.
2.Either:
•Slide the control switch to PILLOW SPEAKER on the rear panel of the TV to control TV and hear audio on pillow speaker.
•For TV speakers sound with pillow speaker control, set the control switch to NORMAL SPEAKER.
Use a pillow speaker that is a UL recognized pendant control bearing the warning: “Risk of fire if used in oxygen enriched atmosphere. Keep pendant control away from oxygen equipment.”
Controlling the TV with Serial Data
The TV is capable of being controlled by a
Controlling the TV with Mechanical Switches
Pin 4 (common) is momentarily connected to pin 1, 3, or 6 via
PILLOW | NORMAL | SWITCH | |
SPEAKER | SPEAKER | ||
| |||
| PILLOW | SPEAKER | |
| SPEAKER |
|
TV
| 4 |
| |
SPKR | 5 |
| |
6 | 3 | ||
| |||
| 1 |
| |
| 2 |
|
VOLUME CONTROL
(MALE
PLUG)
Pin No. | Description |
1 | External TV On/Off switch. |
2 | (Not used) |
3 | External Channel Up switch or Data in. |
4 | Common connection for control, data, and audio |
| output. Impedance to earth ground is a |
| resistor in parallel with a 1100 pf capacitor. |
5 | Isolated audio output. Nominal 14 ohm source |
| impedance with short circuit protection. Intended |
| for a pillow speaker with a |
| volume control. |
6 | External Channel Down switch. |
TV | CHAN |
ON/OFF | DOWN |
1
42
5 | 3 |
|
63
1 | 4 |
|
25
CHAN
UP
TV ON/OFF
OPEN
CHAN UP/DATA IN
COMMON
AUDIO OUT
6
CHAN DOWN
11 |