AMX ALD-H48 instruction manual Setup

Page 19

Using The Touch Panel Pages

Push the Ramp Up and Ramp Down buttons to raise and lower the dimmer levels incrementally.

2.Push the "%" button to open the keypad, type the percentage value for the dimmer.

3.Push Go to set the dimmer intensity.

Setup Page

Opening the Setup page places the ALD-H48 in addressing mode which will allow you to allocate addresses to attached dimmers. It is recommended you address your dimmers at the time your lighting system is first installed. The Setup page has a total of 48 buttons (8 per each of the 6 buses) shown below.

FIG. 10 Setup Page

It is important to remember which bus the dimmer is physically connected to when addressing.

ALD-H48 Lighting Controller	13

Image 19

Contents ALD-H48 AMX Limited Warranty and Disclaimer Software License and Warranty Agreement Page Table of Contents Via Via Ethernet Overview Overview Opening The ALD-H48 Workspace Setting The ALD-H48 IP AddressGetting Started Downloading The ALD-H48 WorkspaceClick Select All Transferring The ALD-H48 Project to a NetLinx MasterAddressing The Dimmers via The Web Interface Using The Web InterfaceDimmer Address Dimmer Control Controlling Dimmers via The WebScene Establishing And Modifying ScenesModify Scene Modify Group Establishing And Modifying GroupsTouch Panel Main Using The Touch Panel PagesDimmer Light Adjustment Setup SetupAddressing Dimmers GroupsCreating a Group Scenes ScenesCreating a Lighting Scene Using The Touch Panel Pages Introduction Advanced ProgrammingOverview Definedevice ImplementationChannel Assignment and Feedback Port MappingChannel Assignment and Feedback Command Interface ?KEYPADADDR-1 KEYPADENABLE-1 KEYPADENABLE-2=STOP ?FWVERSIONKEYPADREMOVEADDR-151 KEYPADREMOVEIDX-1?LIGHTADDR-1 LIGHTREMOVEIDX-2 Lightremoveaddr LIGHTLEVEL-1,102?LIGHTLEVEL-1 LIGHTRAMP-1,UP LIGHTRAMP-1,STOPReinit ?LIGHTSTATE-1?VERSION Command Feedback KEYPADBTN-1,DOUBLECLICK KEYPADENABLE-1LIGHTSTATE-1,ON Device Notes Programming Notes 14111 14112 11411114112 Adding Functions to Modules Commands to The DeviceVia Updating The ALD-H48 FirmwareVia Ethernet RevisionLast05/11/05