Altinex MX2456RM #RF Factory Reset, #RO Operation Reset, # SA n Audio Breakaway, #CSDn Sync Delay

SWITCHERS

needed by the switcher to activate the audio sources that are connected to the unit.

#= Switch number (No. from 1 to 9, default = 0)

n1 = Audio input number (No. from 0 to 6)

n2 = Break Away code (0 = On , 1 = OFF)

n3 = 1 (audio key pressed)

n4 = Sync Delay (No. from 0 to 4)

n5 = Video Equalizer (Hexadecimal no. from 1 to F).

n6 = Audio Gain (Hexadecimal no. from 1 to F).

Example:

Sending the [8SW6012F8] command will activate switcher module 8 and audio input 6 only. Since the break away code is zero (0), 1 alerts the switcher that the audio key was pressed with an interval of 2 (1 second). The video equalizer is set to a maximum and a normal volume of 8 (0 = OFF, default is 8 for normal volume or video).

3.[#RF] - Factory Reset

This command will replace all settings stored in the memory of the switcher module. This is indicated by the factory default settings. All previous settings will be lost.

#= switch number (default is 0)

Example:

Sending the command [8RF] command will reset the Switcher module to the factory settings with ID number eight.

4.[#RO] - Operation Reset

The [#RO] command will reset audio and video to input #1, Auto Switch to OFF and Beep OFF to Beep ON. However, this command will not affect audio volume, video equalization, auto rotation, and sync delay.

#= Switch number (Default no. is 0)

Example:

Sending the [8RO] command resets the switcher module in the Reset Mode with ID number eight.

5.[# SA n] - Audio Breakaway

This command controls how audio and video input are selected. The [# SA n] command allows the user to control audio input and video input independently or simultaneously.

#= switch number (Default no. is 0)

n = 1 (ON) Breakaway Audio Input from Video Input and switchers can be activated independently.

n = 0 (OFF). In this mode the switchers are activated simultaneously. For example, if Video Input 2 is pressed Audio Input 2 will be pressed automatically.

Example:

Sending the [1SA1] command will allow the user to press Audio Input or the Video Input independently.

6.[#CSDn] - Sync Delay

This command allows time delay between switching from one video source to another by avoiding an overlap of communication problems.

#= Switcher module ID number (Default is 0)

n= the time delay interval between video sources and switching inputs

n = 0	Sync Delay is Off (no delay)
n = 1	0.5 second delay
n = 2	1.0 s
n = 3	1.5 s
n = 4	2.0 s

Example:

Sending the [8CSD4] command sets a 2-second time delay between input selection of the connected switcher module with an ID number of 8.

10