Allied Telesis x600-24Ts/XP, x600-48Ts, X600-24TS, X600-48TS/XP Starting a Local Management Session

Starting a Local

Management

Session

x600 Layer 3 Gigabit Ethernet Switch Installation Guide

4.Start a local management session on the unit by performing the next procedure.

The following procedure describes how to connect an RJ-45 cable to an x600 switch. For information about how to log onto the AlliedPlusTM Operating System Software, see the AlliedWare PlusTM Operating System Software Reference Guide.

To start a local management session on the unit, perform the following procedure:

1.Connect the RJ-45 end of the management cable included with the x600 switch to the Terminal Port on the front panel of the switch, as shown in Figure 30.

SD					x600-
9					READY	24Ts/XP				Layer 3	Gigabit
	11	13										Ethernet
			15
				17	BUSY	FAULT		SFP					Switch
					19
						21R	23R	L	/A	CONS	OLE
												STATUS
									21
10	12	14							22			FAULT
			16						23
				18
					20
						22R						MASTER
							24R		24
												RPS
												PWR		RESET
													1320

Figure 30. Connecting the Management Cable to the RJ-45 Terminal Port

on the Switch

2.Connect the other end of the cable to an RS-232 port on a terminal or a personal computer with a terminal emulation program.

3.Configure the terminal or terminal emulation program as follows:

ˆBaud rate: Default is 9600 bps (Range is 9600 to 115200 bps)

ˆData bits: 8

ˆParity: None

ˆStop bits: 1

ˆFlow control: None

Note

The port settings are for a DEC VT100 or ANSI terminal, or an equivalent terminal emulator program.

53