Patch | 5 |
PCR: 03123 Module: DHCP | Level: 3 |
After sending a DHCP NAK in response to a client’s DHCP REQUEST with a bad lease time, the switch would fail to age out its corresponding DHCP OFFER entry. This issue has been resolved.
PCR: 03125 | Module: DS3 | Level: 3 |
The switch would disassert the AIS, IDLE, LOF and LOS alarms if the defect conditions that had caused the alarm were disasserted, then reasserted before the alarms had been disasserted. This issue has been resolved.
PCR: 03127 | Module: IPV6 | Level: 2 |
When a static link local address was configured using the ADD IPV6 INT=xxx IP=yyy command, it was not reflected in the switch’s dynamic configuration. Consequently, the command would be absent from the switch’s configuration after CREATE CONFIG and switch RESTART commands were executed. This issue has been resolved.
PCR: 03136 | Module: BGP | Level: 2 |
The ADD BGP PEER command MAXPREFIX parameter now has a default of 24000, instead of OFF. Previously, with no maximum prefix checking by default, if the switch received a very large number of prefixes from a BGP peer, buffer exhaustion could result in a software restart.
PCR: 03011 | Module: OSPF | Level: 3 |
The SHOW OSPF NEIGHBOUR command did not reflect a change made to the router priority on a dynamic OSPF interface of a neighbouring router. This issue has been resolved.
PCR: 03035 Module: OSPF
Link state advertisements could incorrectly show an area as a stub area. This happened during the time when a Direct Route (DR) was removed from a configuration and before a Direct Backup Route (BDR), or an Other Direct Route (Other DR) was elected. This issue has been resolved.
PCR: 03045 | Module: IPG, SWI | Level: 3 |
The switch would flood DVMRP unicast messages to all ports in the VLAN.
This issue has been resolved.
PCR: 03046 | Module: IPG | Level: 3 |
ICMP packets originating from the switch used the wrong Equal Cost Multiple Path route. This issue has been resolved. Also, improvements have been made to ensure that the ICMP packet will be transmitted over the best available route. If the best route becomes unavailable, a new route will be found, if available, so that the ICMP packet continues to reach the destination address.
PCR: 03051 | Module: PCI | Level: 2 |
The ECPAC card was not working correctly. This issue has been resolved.
Patch