10 | Patch Release Note |
PPPinterface speed. This issue has been resolved so that the LNS side of the PPP interface shows the correct speed.
PCR: 02538 Module: DVMRP | Network affecting: No |
The source mask is now always 0xffffffff in the DVMRP forwarding table.
The temporary route in the DVMRP route table was not displaying correctly. This issue has been resolved.
An IGMP entry was erroneously added for the reserved IP address. This issue has been resolved.
PCR: 02539 | Module: CLASSIFIER | Network affecting: No |
The TCP and UDP source and destination port parameters would accept values of more than 65535. 65535 is now the maximum value for source and destination ports. This complies with RFC768 for UDP and RFC793 for TCP.
PCR: 02542 | Module: IPV6 | Network affecting: No |
The SHOW IPV6 commands were incorrectly including RIPng down routes, and routes on the sending interface. The IPv6 routing table now recognises down routes.
PCR: 02543 | Module: SWI | Network affecting: No |
BPDU messages are now sent to all active ports as soon as STP is enabled.
PCR: 02547 | Module: IPG | Network affecting: No |
The ARP transmit counter total was not being incremented. This issue has been resolved.
PCR: 02550 | Module: FIREWALL | Network affecting: No |
The standard subnet NAT rules on a private interface were not matching a packet unless its source IP address was exactly the same as the IPADDRESS value set for the rule, that is the NAT mask value was not being used. This issue has been resolved.
PCR: 02551 | Module: IPG | Network affecting: No |
Reserved multicast data was being duplicated. This issue has been resolved.
PCR: 02552 | Module: SWI | Network affecting: No |
If ingress filtering was supported within trunk groups, ports with ingress filtering enabled were erroneously added to the trunk group. This issue has been resolved.
PCR: 02564 | Module: FIREWALL | Network affecting: No |
Large RTSP continuation packets could cause a fatal error. This issue has been resolved.
PCR: 02565 | Module: CLASSIFIER | Network affecting: No |
The SET CLASSIFIER and CREATE CLASSIFIER commands now display the tagged and untagged parameters correctly when the PROTOCOL parameter is set to IPX or 802.2.
PCR: 02572 | Module: IPG | Network affecting: No |
An issue introduced in a previous patch with the SET IP ROUTE command failing has been resolved.
Patch