6 | Patch Release Note |
Features in 86241-05
Patch file details are listed in Table 2:
Table 2: Patch file details for Patch
Base Software Release File | |
|
|
Patch Release Date | |
|
|
Compressed Patch File Name | |
|
|
Compressed Patch File Size | 332388 bytes |
|
|
Patch
PCR: 02315 Module: SNMP | Network affecting: No |
Support has been added for SNMPv2c.
SNMP responses will be sent in the same version format as the request message. Minimal configuration is required to specify a SNMP format, because this is decided on a message by message basis. The only thing you need to specify is the version of SNMP received by trap hosts.
To create an SNMP community, use the command:
CREATE SNMP COMMUNITY=name [ACCESS={READWRITE}] [TRAPHOST=ipadd] [MANAGER=ipadd] [OPEN={ONOFFYESNOTRUEFALSE}] [V1TRAPHOST=ipadd]
[V2CTRAPHOST=ipadd]
To add a trap host or management station to the previously created SNMP community, use the command:
ADD SNMP COMMUNITY=name [TRAPHOST=ipadd] [MANAGER=ipadd]
[V1TRAPHOST=ipadd] [V2CTRAPHOST=ipadd]
PCR: 02389 | Module: DS3 | Network affecting: No |
DS3 interface and board type support has been added. DS3 is now supported over PPP and Frame Relay. DS3 MIB support has been added.
For more information on DS3, see “DS3 Interfaces” on page 22 of this release note.
PCR: 02414 | Module: IPv6, SWI, IPG, VLAN Network affecting: No |
This patch resolves issues that arose after previous modifications made under this PCR number.
Sometimes IPv6 features did not enable correctly. Also, there were some errors in the output from configuration commands. These issues have been resolved.
PCR: 02560 | Module: IPG, SWI, VLAN | Network affecting: No |
IP packet throughput has been improved.
Patch