AT-9400 Series Gigabit Ethernet Switches Installation Guide
Stop bits: 1
Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an equivalent terminal emulator program.
4.Press Enter.
You are prompted for a user name and password.
5.To configure the switch settings, enter “manager” as the user name. The default password for manager access is “friend.” To just view the settings, enter “operator” as the user name. The default password for operator access is “operator.” User names and passwords are case sensitive.
6.The local management session starts and the command line interface (CLI) prompt is displayed, as shown in Figure 30.
Allied Telesis Ethernet Switch
<No system name>
#
Figure 30. CLI Prompt
For information about the command line interface, refer to the AT-S63 Management Software Command Line Interface User’s Guide.
7.To use the menus interface, type menu and press Return.
The switch’s Main Menu is displayed. For information, refer to the AT-S63 Management Software Menus Interface User’s Guide.
8.To select a menu item, type the corresponding letter or number. To return to a previous menu, press the Esc key or type the letter R.
65