Menu Items
Network continued
SNMP | The SNMP section displays the SNMP access control and trap receiver | |
| Settings. |
|
|
|
|
| Item | Definition |
|
|
|
| SNMP Access | Enables or disables SNMP access. |
|
|
|
| Access Control | Controls access to each of the four SNMP channels. |
|
|
|
| Trap Receiver | Defines the NMSs (up to 4) to which traps are sent. |
|
|
|
Access Control . The Access Control section of SNMP displays the current settings for all four SNMP channels and lets you configure values for a selected channel.
Item | Definition |
|
|
Community | Password that the NMS specified by the NMS IP option must use |
Name | for SNMP access to the unit. The Access Type option defines |
| the allowed access. |
| Note: Allows a maximum of 15 characters. |
|
|
NMS IP | Configures the channel to allow only one NMS (using a specific |
| NMS IP address), or all NMSs (using 0.0.0.0 for the NMS IP |
| value), to have access to the channel. |
|
|
Access Type | Defines whether the NMS identified by the NMS IP option can |
| write (use GETs and SETs) or read (use only GETs) or is disabled |
| (cannot use GETs or SETs ). |
|
|
Trap Receiver. The Trap Receiver section of SNMP displays and lets you configure the current settings for all four trap receivers.
Item | Definition |
|
|
Community Name | The password that the unit uses when it sends traps to the |
| NMS identified by the Receiver NMS IP option. |
| Maximum length: 15 characters. |
|
|
Receiver NMS IP | The specific NMS (defined by its IP address) to receive traps |
| sent by the unit. |
| Note: To send no traps to any NMS, set the Trap Receiver |
| IP to 0.0.0.0 |
|
|
Trap Generation | Enables or disables the sending of traps to the NMS |
| identified by the Receiver NMS IP option. |
|
|
Authentication Traps | Enables or disables the sending of authentication traps to |
| the NMS identified by the Receiver NMS IP option. |
|
|
| Continued on next page |
Environmental Monitoring Unit: User’s Guide | 14 |