APC AP9465, AP9470, AP9475 Power supply voltage is out of acceptable range specified

Page 26

E1618

PS # Predictive

Power supply voltage is out of acceptable range; specified

 

 

power supply is improperly installed or faulty.

 

 

 

E161C

PS # Input Lost

Power source for specified power supply is unavailable, or out

 

 

of acceptable range.

 

 

 

E1620

PS # Input Range

Power source for specified power supply is unavailable, or out

 

 

of acceptable range.

 

 

 

E1624

PS Redundancy

The power supply subsystem is no longer redundant. If the last

 

 

supply fails, the system will go down.

 

 

 

E1710

I/O Channel Chk

The system BIOS has reported an I/O channel check.

 

 

 

E1711

PCI PERR B## D## F##

The system BIOS has reported a PCI parity error on a

 

PCI PERR Slot #

component that resides in PCI configuration space at bus ##,

 

 

device ##, function ##.

 

 

The system BIOS has reported a PCI parity error on a

 

 

component that resides in the specified PCI slot.

 

 

 

E1712

PCI SERR B## D## F##

The system BIOS has reported a PCI system error on a

 

PCI SERR Slot #

component that resides in PCI configuration space at bus ##,

 

 

device ##, function ##.

 

 

The system BIOS has reported a PCI system error on a

 

 

component that resides in the specified slot.

 

 

 

E1714

Unknown Err

The system BIOS has determined that there has been an error in

 

 

the system, but is unable to determine its origin.

 

 

 

E171F

PCIE Fatal Err B##

The system BIOS has reported a PCIe fatal error on a

 

D## F##

component that resides in PCI configuration space at bus ##,

 

PCIE Fatal Err Slot #

device ##, function ##.

 

 

The system BIOS has reported a PCIe fatal error on a

 

 

component that resides in the specified slot.

 

 

 

E1810

HDD ## Fault

The SAS subsystem has determined that hard drive ## has

 

 

experienced a fault.

 

 

 

E1811

HDD ## Rbld Abrt

The specified hard drive has experienced a rebuild abort.

 

 

 

E1812

HDD ## Removed

The specified hard drive has been removed from the system.

 

 

 

E1913

CPU & Firmware

The BMC firmware does not support the CPU.

 

Mismatch

 

 

 

 

E1A11

PCI Rsr Config

PCI risers are not configured correctly; some invalid

 

 

configurations may prevent the system from turning on.

 

 

 

E1A12

PCI Rsr Missing

One or all of the PCI risers are missing, preventing the system

 

 

from turning on.

 

 

 

E1A14

SAS Cable A

SAS cable A is missing or bad.

 

 

 

E1A15

SAS Cable B

SAS cable B is missing or bad.

 

 

 

E2010

No Memory

No memory is installed in the system.

 

 

 

E2011

Mem Config Err

Memory detected, but is not configurable. Error detected during

 

 

memory configuration.

 

 

 

E2012

Unusable Memory

Memory is configured, but not usable. Memory subsystem

 

 

failure.

 

 

 

E2013

Shadow BIOS Fail

The system BIOS failed to copy its flash image into memory.

 

 

 

E2014

CMOS Fail

CMOS failure. CMOS RAM not functioning properly.

 

 

 

E2015

DMA Controller

DMA controller failure.

 

 

 

E2016

Int Controller

Interrupt controller failure.

 

 

 

22

InfraStruXure Central Installation Manual

Image 26
Contents Installation Manual 동봉된 CD 안에 한국어 매뉴얼이 있습니다 Contents Appendix B Diagnostic Messages Product Description OverviewEquipment containing a battery SafetyRack-mounting safety Before You Begin InstallationInstallation Instructions Remove the rack doors RapidRails Rack Kit ContentsInstallation Tasks Select a location within the rackInstall the RapidRails slide assemblies Install the system in the rack Replace the rack doors Set up the Private LANCommunication Connection Network overviewInstall and route data cables alternative routing Connect the InfraStruXure Central server to your Public LAN Connect the InfraStruXure Central server to your Private LANSystem and Web browser prerequisites Initial ConfigurationConfigure the InfraStruXure Central Server Enable Remote Monitoring Basic model front Product InformationInfraStruXure Central Front Panel Standard model front ItemFunctionEnterprise model front InfraStruXure Central rear panel Basic model rearStandard Model rear Enterprise Model rear Specifications InfraStruXure Central serverOverview Appendix a LED Error CodesError Code Listing InfraStruXure Central Installation Manual Appendix B Diagnostic Messages Message ListingPower supply voltage is out of acceptable range specified Timer refresh failure Non-transferable warranty Exclusions Two-Year Factory WarrantyTerms of warranty Warranties and PoliciesGeneral policy Warranty claimsLife Support Policy Examples of life-support devicesInfraStruXure Central Installation Manual Page 990-3321-001 06/2008