APC AP9475, AP9470, AP9465 installation manual Install the system in the rack

Page 10

Install the system in the rack

Caution:

• If you are installing more than one system, install the first system in the lowest available position in the rack.

Never pull more than one component out of the rack at a time.

Because of the size and weight of the system, never attempt to install the system in the slide assemblies by yourself.

1.Pull the two slide assemblies out of the rack until they lock in the fully extended position. Lift the system into position in front of the extended slides (see below).

shoulder screw on system system locking mechanism

2.Place one hand on the front-bottom of the system and the other hand on the back-bottom of the system.

3.Tilt the back of the system down while aligning the back shoulder screws on the sides of the system with the back slots on the slide assemblies.

4.Engage the back shoulder screws into their slots.

5.Lower the front of the system and engage the front and middle shoulder screws in their slots (the middle slot is just behind the yellow system release latch). When all shoulder screws are properly seated, the system locking mechanism at the front of each slide assembly clicks and locks the system into the slide assembly.

6

InfraStruXure Central Installation Manual

Image 10
Contents Installation Manual 동봉된 CD 안에 한국어 매뉴얼이 있습니다 Contents Appendix B Diagnostic Messages Product Description OverviewRack-mounting safety SafetyEquipment containing a battery Installation Instructions InstallationBefore You Begin Remove the rack doors RapidRails Rack Kit ContentsInstallation Tasks Select a location within the rackInstall the RapidRails slide assemblies Install the system in the rack Replace the rack doors Set up the Private LANCommunication Connection Network overviewInstall and route data cables alternative routing Connect the InfraStruXure Central server to your Public LAN Connect the InfraStruXure Central server to your Private LANConfigure the InfraStruXure Central Server Initial ConfigurationSystem and Web browser prerequisites Enable Remote Monitoring InfraStruXure Central Front Panel Product InformationBasic model front Standard model front ItemFunctionEnterprise model front InfraStruXure Central rear panel Basic model rearStandard Model rear Enterprise Model rear Specifications InfraStruXure Central serverError Code Listing Appendix a LED Error CodesOverview InfraStruXure Central Installation Manual Appendix B Diagnostic Messages Message ListingPower supply voltage is out of acceptable range specified Timer refresh failure Non-transferable warranty Exclusions Two-Year Factory WarrantyTerms of warranty Warranties and PoliciesGeneral policy Warranty claimsLife Support Policy Examples of life-support devicesInfraStruXure Central Installation Manual Page 990-3321-001 06/2008