APC AP9475, AP9470 Product Information, InfraStruXure Central Front Panel, Basic model front

Product Information

InfraStruXure Central Front Panel

Basic model (front)

Item		Function
	Diagnostic	The four diagnostics indicators on the system front panel display
	Indicators	error codes during system startup.
	Power-on	The power-on indicator lights when the system power is on. The
	Indicator,	power-on indicator blinks when the system is not turned on but
	Power Button	power is available. The power button controls the power supply
		output to the system.
	NMI button	The NMI button is used to troubleshoot software and device driver
		errors when using certain operating systems. This button can be
		pressed using the end of a paper clip. Use this button only if
		directed to do so by qualified support personnel.

USB Ports (2) Used to connect USB 2.0-compliant devices to the system.

	HDD LED	Hard disk drive LED. When this LED is amber, the disk is being
		accessed.
	Monitor	VGA monitor port
	System	The identification buttons on the front and back panels can be used
	Identification	to locate a particular system within a rack. When one of these
	Button	buttons is pushed, the blue system status indicator on the front and
	Blue and Amber	back blinks until one of the buttons is pushed again.
	System Status	LEDs illuminate as described below to indicate system status:
	Indicator LEDs
		• Blue Off, Amber Off: System is turned off.
		• Blue Off, Amber Blinking: The system has detected an error.
		• Blue On, Amber Off: Power is turned on, system is operational.
		• Blue Blinking, Amber Off: The system identification indicator
		has been activated to identify the system in a rack.

12 InfraStruXure Central Installation Manual