Advantech EKI-7657C user manual Port Mirroring Commands Set, 13 802.1x Commands Set

sub-oid
[OID]
show snmp	P	Show SNMP configuration	switch#show snmp
no snmp community-strings	G	Remove the specified community.	switch(config)#no snmp community-strings public
[Community]
no snmp-server host	G	Remove the SNMP server host.	switch(config)#no snmp-server host 192.168.1.50
[Host-address]
no snmpv3 user	G	Remove specified user of SNMPv3	switch(config)#no snmpv3 user Test
[User Name]		agent.
no snmpv3 access context-name		Remove specified access table of	switch(config)#no snmpv3 access context-name
[Context Name ]		SNMPv3 agent.	Test group G1 security-level AuthPr
group			iv match-rule Exact views V1 V1 V1
[Group Name ]
security-level
[NoAuthNoPrivAuthNoPrivAuthPriv]	G
match-rule
[ExactPrifix]
views
[Read View Name] [Write View Name]
[Notify View Name]
no snmpv3 mibview view		Remove specified mibview table of	switch(config)#no snmpv3 mibview view V1 type
[View Name]		SNMPV3 agent.	Excluded sub-oid 1.3.6.1
type	G
[ExcludedIncluded]
sub-oid
[OID]

3.1.12Port Mirroring Commands Set

Table 3.12: Port Mirroring Commands Set

Netstar Commands	Level	Description	Example
monitor rx	G	Set RX destination port of monitor	switch(config)#monitor rx
		function
monitor tx	G	Set TX destination port of monitor	switch(config)#monitor tx
		function
show monitor	P	Show port monitor information	switch#show monitor
monitor	I	Configure source port of monitor	switch(config)#interface fastEthernet 2
[RXTXBoth]		function	switch(config-if)#monitor RX
show monitor	I	Show port monitor information	switch(config)#interface fastEthernet 2
			switch(config-if)#show monitor
no monitor	I	Disable source port of monitor	switch(config)#interface fastEthernet 2
		function	switch(config-if)#no monitor

3.1.13802.1x Commands Set

Table 3.13: 802.1x Commands Set

Netstar Commands	Level	Description	Example
8021x enable	G	Use the 802.1x global	switch(config)# 8021x enable
		configuration command to enable
		802.1x protocols.
8021x system radiusip		Use the 802.1x system radius IP	switch(config)# 8021x system radiusip 192.168.1.1
[IP address]	G	global configuration command to
		change the radius server IP.
8021x system serverport	G	Use the 802.1x system server port	switch(config)# 8021x system serverport 1812
[port ID]		global configuration command to

35 Chapter3