RuggedCom RS900L manual Dielectric Strength Testing

Page 12

2.2.4 Dielectric Strength Testing

Units which are to have dielectric strength testing (HIPOT testing) done in the field must have the braided ground cable disconnected during the test. This is required in order to prevent the surge suppression circuitry, which is connected to surge ground, from being activated.

Figure 7 - Dielectric Strength Testing

	12
 2007 RuggedCom Inc. All rights reserved	Rev101

Image 12

Contents RuggedSwitch RS900L Installation GuideTrademarks Table of Contents Table of Figures Feature Highlights Product OverviewFunctional Overview Front Panel Description Front Panel DescriptionBottom Panel Description Bottom Panel DescriptionInstallation Din Rail MountingPower Supply Wiring and Grounding AC Power Supply Wiring and GroundingDC Power Supply Wiring and Grounding DC Power supply wiring and grounding diagramFailsafe Output Wiring Failsafe Output RelayDielectric Strength Testing Dielectric Strength TestingRS232 Console Port Wiring RS232 Female DCE pin-outEthernet Ports RJ11 Ethernet over Vdsl PortOverview Wiring Configuration & SetupPerformance  2007 RuggedCom Inc. All rights reserved Rev101 RJ45 Ethernet Ports RJ45 port pin-out and LEDs 2007 RuggedCom Inc. All rights reserved Rev101 100FX Mtrj connector Fiber Optic Ethernet PortsTechnical Specifications Power Supply SpecificationsFailsafe Relay Specifications Operating EnvironmentRJ11 Ethernet over Vdsl Port Specifications RJ45 Ethernet Port SpecificationsFiber Optic Ethernet Port Specifications Communication StandardsMechanical Specifications Parameter ValueType Tests IEC 61850-3 Type TestsIeee 1613 Type Tests IEC Environmental Type TestsWarranty