RuggedCom RS900L manual  2007 RuggedCom Inc. All rights reserved Rev101

Page 18

NOTE: RuggedCom does not recommend the use of copper cabling of any length for critical real- time substation automation applications. However, transient suppression circuitry is present on all copper ports to protect against damage from electrical transients and to ensure IEC 61850-3 and IEEE 1613 Class 1 conformance. This means that during the transient event communications errors or interruptions may occur but recovery is automatic.

RuggedCom also does not recommended to use these ports to interface to field devices across distances which could produce high levels of ground potential rise, (i.e. greater than 2500V) during line to ground fault conditions.

	18
 2007 RuggedCom Inc. All rights reserved	Rev101

Image 18

Contents RuggedSwitch RS900L Installation GuideTrademarks Table of Contents Table of Figures Feature Highlights Product OverviewFunctional Overview Front Panel Description Front Panel DescriptionBottom Panel Description Bottom Panel DescriptionInstallation Din Rail MountingPower Supply Wiring and Grounding AC Power Supply Wiring and GroundingDC Power Supply Wiring and Grounding DC Power supply wiring and grounding diagramFailsafe Output Wiring Failsafe Output RelayDielectric Strength Testing Dielectric Strength TestingRS232 Console Port Wiring RS232 Female DCE pin-outEthernet Ports RJ11 Ethernet over Vdsl PortOverview Wiring Configuration & SetupPerformance  2007 RuggedCom Inc. All rights reserved Rev101 RJ45 Ethernet Ports RJ45 port pin-out and LEDs 2007 RuggedCom Inc. All rights reserved Rev101 100FX Mtrj connector Fiber Optic Ethernet PortsFailsafe Relay Specifications Technical SpecificationsPower Supply Specifications Operating EnvironmentRJ11 Ethernet over Vdsl Port Specifications RJ45 Ethernet Port SpecificationsFiber Optic Ethernet Port Specifications Communication StandardsMechanical Specifications Parameter ValueType Tests IEC 61850-3 Type TestsIeee 1613 Type Tests IEC Environmental Type TestsWarranty