RuggedCom RS900L manual RS232 Console Port Wiring, RS232 Female DCE pin-out

Page 13

2.3 RS232 Console Port Wiring

The RS232 port is used for configuring the unit. A straight-through serial cable with a DB-9 connector is required. There is no need to crossover the Transmit and Receive signals from the PC side since this has been done internally as is shown below.

Figure 8 - RS232 Female DCE pin-out

Pin

1

2

3

4

5

6

7

8

9

Signal

No Connection

Transmit Data

Receive Data

No Connection

Ground

No Connection

No Connection

No Connection

No Connection

Table 2 - RS232 Female DCE pin-out

NOTE: This port is not intended to be a permanent connection and the cable shall be less than 2m (6.5 ft) in length.

	13
 2007 RuggedCom Inc. All rights reserved	Rev101

Image 13

Contents Installation Guide RuggedSwitch RS900LTrademarks Table of Contents Table of Figures Product Overview Feature HighlightsFunctional Overview Front Panel Description Front Panel DescriptionBottom Panel Description Bottom Panel DescriptionDin Rail Mounting InstallationAC Power Supply Wiring and Grounding Power Supply Wiring and GroundingDC Power supply wiring and grounding diagram DC Power Supply Wiring and GroundingFailsafe Output Relay Failsafe Output WiringDielectric Strength Testing Dielectric Strength TestingRS232 Female DCE pin-out RS232 Console Port WiringRJ11 Ethernet over Vdsl Port Ethernet PortsOverview Configuration & Setup WiringPerformance  2007 RuggedCom Inc. All rights reserved Rev101 RJ45 port pin-out and LEDs RJ45 Ethernet Ports 2007 RuggedCom Inc. All rights reserved Rev101 Fiber Optic Ethernet Ports 100FX Mtrj connectorPower Supply Specifications Technical SpecificationsFailsafe Relay Specifications Operating EnvironmentRJ45 Ethernet Port Specifications RJ11 Ethernet over Vdsl Port SpecificationsCommunication Standards Fiber Optic Ethernet Port SpecificationsParameter Value Mechanical SpecificationsIEC 61850-3 Type Tests Type TestsIEC Environmental Type Tests Ieee 1613 Type TestsWarranty