3Com 9000 manual MNG Management setup, SIP IP Setup, SIP Set IP Address, Next reboot

Setting Up for Management 57

Update IP Address Update the IP address of the CoreBuilder 9000 ATM Enterprise Switch. The default factory IP address is 0.0.0.0.

The IP address is changed after the next reboot.

Command Actions

Enter the menu sequence:	(1) SYS: Platform configuration
	(1) SET: Switch setup
	(2) MNG: Management setup
	(1) SIP: IP Setup
	(2) SIP: Set IP Address
Enter a parameter at the prompt
Parameter	Format or Range
IP Address	Valid IP address
Direct access sequence:	1 1 2 1 2 [parameters]
Command Result
System action taken:	The IP address is updated.
System message display:	IP address was successfully set for
	next reboot.

Example

Enter: 1 1 2 1 2 100.0.2.2

The following message is displayed:

IP address was successfully set for next reboot.

The IP address is updated to 100.0.2.2 and takes effect after the next reboot.

CAUTION: Make sure to change the factory default IP address to a valid IP address that matches your network IP addresses.