3Com 9000 Enter 1 5 3 5.1.1 Following messages are displayed, Selected ports are set and saved

96CHAPTER 5: CONFIGURING THE PLATFORM

Set Port Frame Mode Set the interface mode of the selected port as SDH or SONET and save to flash memory. You are prompted to specify a port and a mode.

Command Actions

Enter the menu sequence: (1) SYS: Platform Configuration

(5) IFC: Interface Cards

		(3) SFM: Set Port Frame Mode
Enter a parameter at the prompt
Parameter	Format or Range
Port ID	slot.group.port (0.0 - For all)
Frame Mode	0	- SDH
	1	- SONET
Direct access sequence:	1	5 3 [parameters]

Command Result

System action taken:

System message display:

The frame mode of the selected port on the interface module is set and saved.

Setting port frame mode has completed

successfully.

CAUTION: When setting the port frame mode on one of the ports of an OC-3c or 155 Mbps-over-UTP5 card, all four ports are automatically updated, even if only one port was selected.

Example

Enter: 1 5 3 5.1.1 0

The following messages are displayed:

The following	settings will take place:
Changing port	<5.1.1> setting from SONET mode to SDH mode.
Changing port	<5.1.2> setting from SONET mode to SDH mode.
Changing port	<5.1.3> setting from SONET mode to SDH mode.
Changing port	<5.1.4> setting from SONET mode to SDH mode.
Do you really	want to do these changes? (Y/N)? y

Enter y to confirm. The following message is displayed:

Setting port frame mode has completed successfully.

The selected port(s) are set and saved.