3Com 9000 manual Interface Card Parameters, Interface Parameters

94CHAPTER 5: CONFIGURING THE PLATFORM

Interface Module slot occupancy information for the 7-slot chassis is displayed as follows:

Slot id	Slot status	Interface card type Interface card status
-------	------------	------------------- ---------------------
1	Occupied	ATM I/F card		Up
2	Free			Doesn’t exist
3	Free			Doesn’t exist
4	Free			Doesn’t exist
5	Occupied ATM I/F card		Up
6	Free			Doesn’t exist
7	Free			Doesn’t exist

Interface Card Parameters

Table 15 describes the interface parameters displayed by the command for a specific slot ID.

Table 15 Interface Parameters

Parameter	Description
Port ID	The port number for each of the module’s ports in the
	format slot.group.port.
Interface Type	The port interface type (for example, OC3-SC). The type
	determines the interface, including the type of connector.
Media Type	The type of media used by the port (for example, coaxial
	cable, multi-mode fiber).
Operational Status	The port may be “up” or “down”, “up & connect” , or
	“doesn’t exist.”
Port Status	Whether the port has been enabled or disabled by
	management. Can be either “enabled” or “disabled”. If a
	port is disabled, the CoreBuilder® 9000 cannot connect to
	the other side via this port.
Frame Mode	The interface framing mode. Can be SDH or SONET.
Clock Src	This may be normal (Nrm) or Loop timing (Lpt).
Loop Mode	Indicate the loopback state of the ATM interface module
	port. May be “None”, “Loop Forward” or “Loop Back”.