Rosewill RNX-N400LX user manual Wireless - WDS Settings, Description

Wireless RouterRNX-N400LX User Manual

3.35 Wireless – WDS Settings

Wireless Distribution System uses wireless media to communicate with other APs, like the Ethernet does. To do this, you must set these APs in the same channel and set MAC address of other AP that you want to communicate with in the table and then enable the WDS.

Item	Description
Enable WDS	Click the check box to enable wireless distribution system.
MAC Address	Fill in the MAC address of AP to register the wireless distribution
	system access capability.
Data Rate	Select the transmission data rate from pull-down menu. Data rate
	can be auto-select, 1M to 54Mbps or MCS.
Comment	Fill in the comment tag for the registered client.
Apply Changes	Click the Apply Changes button to complete the new configuration
	setting.
Reset	Click the Reset button to abort change and recover the previous
	configuration setting.
Set Security	Click button to configure wireless security like WEP(64bits),
	WEP(128bits), WPA(TKIP), WPA2(AES) or None
Show Statistics	It shows the TX, RX packets, rate statistics.
Delete Selected	Click to delete the selected clients that will be access right removed
	from this WLAN Broadband Router.
Delete All	Click to delete all the registered clients from the access allowed list.
Reset	Click the Reset button to abort change and recover the previous
	configuration setting.

3.351 WDS Security Setup

Requirement: Set [Wireless]->[Basic Settings]->[Mode]->AP+WDS

This page is used to configure the wireless security between APs.

26