Rose electronic QuadraVista manual → ← → ← or ← → ← →, System / HotMouse

Page 19

When the multiple key and double click key assignment has been made, exit the menu system and these values will be saved.

If you assigned the Control, Alt, and Shift keys (menu value = “Yes”) to be the multiple key HOTKEY, then you must press these three keys simultaneously plus the command key.

If the shift key was assigned to be the double click HOTKEY, then you must press the shift key twice then the command key.

System / HotMouse

The Hotmouse works similarly to the HOTKEY function where an operation is activated using only the mouse. To use the Hotmouse feature, it first must be enabled. Navigate to the SYSTEM / Hotmouse window and enable the Hotmouse (set to “Yes”) and set the timeout value (1 to 30 sec.). This determines how long the selection window is displayed.

Enabling the HOTMOUSE feature, you can perform several functions using only the mouse:

(Switch channels, size PiP window, and other features)

Figure 7. System HotMouse

To activate the Hotmouse cursor feature, move the mouse rapidly in alternating horizontal directions four times (Note: the Hotmouse must be enabled for this feature to function).

→ ← → ← or ← → ← →

The Hotmouse cursor will change depending on the view mode. Activating the Hotmouse in the Full screen mode will temporarily display the PiP images of the non-selected channels (see below). Moving the cursor to a PiP image and clicking on the left mouse button will switch, full screen, to that channel.

QUADRAVISTA INSTALLATION AND OPERATIONS MANUAL

13

 

 

Image 19
Contents QuadraVista Page Limited Warranty Declaration of Conformity Declaration of ConformityTable of Contents Figures System Introduction IntroductionFeatures Rose Electronics web site About this manual Package contentsCompatibility Product RegistrationFront View Selector buttons ModelsInstallation InstallationInstalling the KVM station CPU Connect Installing the ComputersFront Panel LEDs / Push-Button Commands CommandsChannel select window Hotkey + P Keyboard CommandsOn Screen Menu System On Screen DisplaySystem menu Main MenuHotkey System / HotKeySystem / HotMouse → ← → ← or ← → ← →Active channel Hotmouse Menu System OSD Position System Quad ModeSystem / Security System / OSD LanguageEdid Quadravista Installation and Operations Manual System / Test Pattern System / Test PatternSystem / Control System / Disable ChannelMode Mode / PiP-StartConfigure / Backup, Recall, Factory Reset ConfigureRecall Video output / Keyboard / Multi-Monitor / Edid ConsoleConsole, Video output Console / KeyboardExample Multi-Monitor Console / Multi-MonitorConsole / Edid VideoVideo / Video Input Video Brightness / Contrast Video / Brightness / ContrastHorizontal Position Video / Horizontal and Vertical positionVideo / Screen width Video / PhaseVideo / Format ComputerComputer / Mouse Computer / KeyboardComputer / Change EDID/DDC Computer / Reset PS/2Edid Programming Help Help / CommandHelp / Contact Serial Operation Serial FeaturesDCP Synchronizing Multiple Units Quadravista Installation and Operations Manual DCP/XML Feature Quadravista Installation and Operations Manual Response to the above query is DCP/XML System QueryingDCP error messages Line length maximum 38 characters Maintenance and Repair Service InformationTechnical Support Safety SafetyGrounding Safety and EMC Regulatory StatementsAppendices Appendix A. SpecificationsAppendix B. Parts and cables Appendix C. Factory Defaults Section Function Default SettingAppendix D. Supported Video-In Formats Quadravista Installation and Operations Manual Page Stancliff Road