Planet Technology WAP-6100 user manual Wep, Authentication type

Page 19

WPA security mode. Once you setup the AP to work in security mode, all wireless stations will also need to have corresponding settings. System default setting is “No Security”.

WEP

Authentication type

Select the appropriate value - "Open System" or "Shared Key". All Wireless stations must then be set to use the same method.

Image 19
Contents 802.11g Wireless LAN Outdoor CPE AP Copyright Safety Table of Contents Page Introduction Package ContentsFeatures SpecificationWireless Performance Environmental factors Site selectionHardware Installation Outdoor Installation Warning DON’T Touch That PERSON, or YOU MAY be Electrocuted Setup Procedures Initial SetupClick on Start Menu/ Run Page System Information Web ConfigurationAccess Point Mode System SummaryCurrent IP Settings Wireless Station ListCurrent Wireless Settings Device Name AdministrationOperation Mode System PropertiesIP Settings Wireless Security Wireless NetworkSsid WEP Authentication typeWPA-PSK Radius secret WPARadius server Radius portWireless Advanced Settings RTS/CTS threshold Protection modeFragment length 256-2346Default settings Current settings immediately Backup / Restore SettingsMAC Filter Reboot Firmware UpgradeConnection Status Wireless Client ModeBssid Site Survey Network modeEthernet Client List Repeater ModeWireless Network WDS Link Settings Wireless BridgeConsiderations before installation WDS Security SettingsAppendix a Glossary