Planet Technology WAP-6100 user manual Wireless Client Mode, Connection Status

Page 26

4.2 Wireless Client Mode

WAP-6100 can also work as an Ethernet client bridge to connect up to 16 Ethernet device into wireless network. In order to setup the WAP-6100 to work in Ethernet bridge mode, you need to choose “Wireless Client” mode and click “Apply” at System Properties page. You also need to reboot the WAP-6100. After the system reboot is done, you can see the page as below. Status page shows the WAP-6100 is now working in Wireless Client mode.

4.2.1 Connection Status

Image 26

Contents 802.11g Wireless LAN Outdoor CPE AP Copyright Safety Table of Contents Page Specification Package ContentsFeatures IntroductionWireless Performance Site selection Environmental factorsHardware Installation Outdoor Installation Warning DON’T Touch That PERSON, or YOU MAY be Electrocuted Click on Start Menu/ Run Initial SetupSetup Procedures Page System Summary Web ConfigurationAccess Point Mode System InformationCurrent Wireless Settings Wireless Station ListCurrent IP Settings System Properties AdministrationOperation Mode Device NameIP Settings Ssid Wireless NetworkWireless Security Authentication type WEPWPA-PSK Radius port WPARadius server Radius secretWireless Advanced Settings 256-2346 Protection modeFragment length RTS/CTS thresholdMAC Filter Backup / Restore SettingsDefault settings Current settings immediately Firmware Upgrade RebootWireless Client Mode Connection StatusBssid Network mode Site SurveyRepeater Mode Ethernet Client ListWireless Network Wireless Bridge WDS Link SettingsWDS Security Settings Considerations before installationAppendix a Glossary