Planet Technology WAP-6100 user manual Copyright

Page 2

Copyright

Copyright2006 by PLANET Technology Corp. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of PLANET.

PLANET makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is". Should the programs prove defective following their purchase, the buyer (and not this company, its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. Further, this company reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation to notify any person of such revision or changes..

All brand and product names mentioned in this manual are trademarks and/or registered trademarks of their respective holders.

FCC Caution:

To assure continued compliance.(example-use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the Following two conditions: (1) This device may not cause harmful interference, and (2 ) this Device must accept any interference received, including interference that may cause undesired operation.

Federal Communication Commission (FCC) Radiation Exposure Statement

This equipment complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20 cm(8 inches) during normal operation.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Protection requirements for health and safety – Article 3.1a

Testing for electric safety according to EN 60950 has been conducted. These are considered relevant and sufficient.

Protection requirements for electromagnetic compatibility – Article 3.1b

Testing for electromagnetic compatibility according to EN 301 489-1, EN 301 489-17 and EN 55024

has been conducted. These are considered relevant and sufficient.

Image 2
Contents 802.11g Wireless LAN Outdoor CPE AP Copyright Safety Table of Contents Page Specification Package ContentsFeatures IntroductionWireless Performance Site selection Environmental factorsHardware Installation Outdoor Installation Warning DON’T Touch That PERSON, or YOU MAY be Electrocuted Click on Start Menu/ Run Initial SetupSetup Procedures Page System Summary Web ConfigurationAccess Point Mode System InformationCurrent Wireless Settings Wireless Station ListCurrent IP Settings System Properties AdministrationOperation Mode Device NameIP Settings Ssid Wireless NetworkWireless Security Authentication type WEPWPA-PSK Radius port WPARadius server Radius secretWireless Advanced Settings 256-2346 Protection modeFragment length RTS/CTS thresholdMAC Filter Backup / Restore SettingsDefault settings Current settings immediately Firmware Upgrade RebootWireless Client Mode Connection StatusBssid Network mode Site SurveyRepeater Mode Ethernet Client ListWireless Network Wireless Bridge WDS Link SettingsWDS Security Settings Considerations before installationAppendix a Glossary