Planet Technology WAP-6100 user manual Wireless Bridge, WDS Link Settings

Page 31

4.4 Wireless Bridge

Wireless Bridge mode help to make the two or more Ethernet networks connected without any wire. With multiple WAP-6100s in this mode, several LANs in distance can communicate to each other. This could be deployed if the networks are hard to make the wire in between.

4.4.1 WDS Link Settings

In the “WDS Link Settings”, select “Enable” in the “Mode” field. Then you are able to fill in MAC

Address of each target WAP-6100.

Image 31

Contents 802.11g Wireless LAN Outdoor CPE AP Copyright Safety Table of Contents Page Introduction Package ContentsFeatures SpecificationWireless Performance Environmental factors Site selectionHardware Installation Outdoor Installation Warning DON’T Touch That PERSON, or YOU MAY be Electrocuted Setup Procedures Initial SetupClick on Start Menu/ Run Page System Information Web ConfigurationAccess Point Mode System SummaryCurrent IP Settings Wireless Station ListCurrent Wireless Settings Device Name AdministrationOperation Mode System PropertiesIP Settings Wireless Security Wireless NetworkSsid WEP Authentication typeWPA-PSK Radius secret WPARadius server Radius portWireless Advanced Settings RTS/CTS threshold Protection modeFragment length 256-2346Default settings Current settings immediately Backup / Restore SettingsMAC Filter Reboot Firmware UpgradeConnection Status Wireless Client ModeBssid Site Survey Network modeEthernet Client List Repeater ModeWireless Network WDS Link Settings Wireless BridgeConsiderations before installation WDS Security SettingsAppendix a Glossary