Planet Technology WAP-6100 user manual Hardware Installation

Page 9

Chapter 2 Hardware Installation

Before you proceed with the installation, it is necessary that you have enough information about the WAP-6100.

1.Locate an optimum location and use the provided metal ring to secure WAP-6100 to a mast.

2.Using provided CAT5 waterproof cable; connect the waterproof connector port of the WAP-6100 to the “P+DATA OUT” port of PoE Injector.

3.Using Category 3 or higher UTP or STP cable, connect the “DATA IN” port of PoE Injector to a 10Mbps or 10/100Mbps Ethernet hub or switch, and connect the management station to a hub or switch on the same LAN.

4.Connect the power cord to the PoE Injector, and plug it into an AC outlet to power up the WAP-6100.

Note: ONLY use the power adapter supplied with the WAP-6100. Otherwise, the product may be damaged.

Image 9

Contents 802.11g Wireless LAN Outdoor CPE AP Copyright Safety Table of Contents Page Features Package Contents Specification IntroductionWireless Performance Environmental factors Site selectionHardware Installation Outdoor Installation Warning DON’T Touch That PERSON, or YOU MAY be Electrocuted Initial Setup Setup ProceduresClick on Start Menu/ Run Page Access Point Mode Web ConfigurationSystem Summary System InformationWireless Station List Current IP SettingsCurrent Wireless Settings Operation Mode AdministrationSystem Properties Device NameIP Settings Wireless Network Wireless SecuritySsid WEP Authentication typeWPA-PSK Radius server WPARadius port Radius secretWireless Advanced Settings Fragment length Protection mode256-2346 RTS/CTS thresholdBackup / Restore Settings Default settings Current settings immediatelyMAC Filter Reboot Firmware UpgradeConnection Status Wireless Client ModeBssid Site Survey Network modeEthernet Client List Repeater ModeWireless Network WDS Link Settings Wireless BridgeConsiderations before installation WDS Security SettingsAppendix a Glossary