Powerware IPK-0320, IPK-0318, IPK-0319 manual BestLink SNMP/WEB Adapter Main Menu Screen

Page 15

Local Configuration

4.Turn on the UPS.

After a few seconds the PC displays a message indicating that the adapter is ready.

5.Press [Enter]. The Password screen appears (see Figure 6). If the Password screen does not appear, press [Enter] again.

If you still do not see the Password screen, check the following conditions:

:The communication settings of the terminal should be 9600 baud, No parity, 8 bits, and 1 stop bit.

:If the serial configuration is correct, check the cabling to verify all connections are secure.

:Verify that your terminal program is on the correct communication port for the serial connection.

:Verify that the UPS has input power and is turned on.

6.Type your password (the default password is admin) and press [Enter]. The Main Menu screen appears.

+============================================================================+

[ BestLink SNMP/WEB Adapter Configuration Utility ] +============================================================================+

Enter Password: *****

+============================================================================+

[ BestLink SNMP/WEB Adapter Configuration Utility ] +============================================================================+

1.SNMP/WEB Card Settings

2.Reset Configuration to default

3.Restart SNMP/WEB Card

0. Exit

Please Enter Your Choice =>_

Figure 6. BestLink SNMP/WEB Adapter Main Menu Screen

BestLink SNMP/WEB Adapter User’s Guide : LTM-1343 B Draft 10/03/2001

9

Image 15
Contents Bestlink SNMP/WEB Adapter Requesting a Declaration of Conformity Class a EMC StatementsFCC Part EN50091-2 Page Page Table of Contents Appendix Introduction System Application BestLink SNMP/WEB Adapter System Application DiagramInstalling the Internal BestLink Adapter InstallationInstalling the Internal BestLink Adapter Installing the External BestLink AdapterInstalling the External BestLink Adapter Configuration Configuring the Adapter LocallyConfiguring the Adapter Remotely Before You Start Local ConfigurationCable Connection with External BestLink Adapter Connecting the BestLink SNMP/WEB AdapterBestLink SNMP/WEB Adapter Main Menu Screen SNMP/WEB Adapter Settings Screen Configuring the AdapterExiting the Configuration Program Set Write Access Managers Set the IP Address, Gateway Address and MIB System GroupSet SNMP/WEB Card Control Group UPS Event Actions Set UPS InformationSet Trap Receivers Set IP Addresses of Primary and Secondary Date ServerSet Superuser Name and Password Mail NotificationBack to Main Menu Remote Configuration Add a Routing Condition in the PCRoute add 192.168.7.18 BestLink Adapter Home Running the Web BrowserSetup Network Configuration Remote Configuration UPS Power Management UPS Management from a Web BrowserBecoming a Superuser Forcing the UPS to Shut Down Turning the UPS On and OffMail Notification Configuring E-mail NotificationPlanning a Scheduled UPS Shutdown and Restart UPS Shutdown SchedulePerforming a Manual UPS Battery Test Scheduling a UPS Battery TestSelect Battery Test Schedule UPS Management from an Snmp NMS Viewing the UPS History LogsViewing the UPS Status with CheckUPS-like Applet Receiving Event Traps Viewing UPS Monitoring ParametersAutomatic Shutdown of UPS-Protected Computers UPS Power Management Appendix Technical SpecificationsExternal BestLink Adapter Rear Panel Adapter ComponentsLED Definitions DIP Switch DescriptionDIP Switch Modes LED DescriptionPin Assignments Serial Cable Definition External BestLink Adapter to UPS Serial ConnectionExternal BestLink Adapter to PC Serial Connection Upgrading the BestLink Adapter Firmware 852-2830-3030 Service and SupportExtended Service Coverage Two-Year Limited Warranty US and Canada OnlyForce Majeure International Limited WarrantyAppendix Page LTM-1343 B