Powerware IPK-0320, IPK-0318, IPK-0319 Remote Configuration, Add a Routing Condition in the PC

Page 21

C H A P T E R 4

REMOTE CONFIGURATION

Use the following procedure to use the adapter’s configuration program through a web browser.

NOTE Verify that an active 10BaseT cable is connected to the adapter’s network connector.

Add a Routing Condition in the PC

If the IP address of the PC is on the same network with the BestLink Adapter, you may just run the web browser directly.

If the IP address of the PC is not in the same network with the BestLink Adapter (only required while configuring the adapter), you can use the Add Routing command.

1.Turn on the PC and set up the TCP/IP protocol if needed.

2.Enter the following command to add a routing condition:

Route add 192.168.7.18 192.72.173.20

where 192.72.173.20 is an example IP address for the PC and 192.168.7.18 is the default IP address of the adapter.

NOTE Refer to your operating system documentation for additional details on how to add a routing condition.

BestLink SNMP/WEB Adapter User’s Guide : LTM-1343 B Draft 10/03/2001

15

Image 21
Contents Bestlink SNMP/WEB Adapter Requesting a Declaration of Conformity Class a EMC StatementsFCC Part EN50091-2 Page Page Table of Contents Appendix Introduction System Application BestLink SNMP/WEB Adapter System Application DiagramInstalling the Internal BestLink Adapter InstallationInstalling the Internal BestLink Adapter Installing the External BestLink AdapterInstalling the External BestLink Adapter Configuration Configuring the Adapter LocallyConfiguring the Adapter Remotely Before You Start Local ConfigurationCable Connection with External BestLink Adapter Connecting the BestLink SNMP/WEB AdapterBestLink SNMP/WEB Adapter Main Menu Screen SNMP/WEB Adapter Settings Screen Configuring the AdapterExiting the Configuration Program Set Write Access Managers Set the IP Address, Gateway Address and MIB System GroupSet SNMP/WEB Card Control Group Set Trap Receivers Set UPS InformationSet IP Addresses of Primary and Secondary Date Server UPS Event ActionsSet Superuser Name and Password Mail NotificationBack to Main Menu Remote Configuration Add a Routing Condition in the PCRoute add 192.168.7.18 BestLink Adapter Home Running the Web BrowserSetup Network Configuration Remote Configuration UPS Power Management UPS Management from a Web BrowserBecoming a Superuser Forcing the UPS to Shut Down Turning the UPS On and OffPlanning a Scheduled UPS Shutdown and Restart Configuring E-mail NotificationUPS Shutdown Schedule Mail NotificationPerforming a Manual UPS Battery Test Scheduling a UPS Battery TestSelect Battery Test Schedule UPS Management from an Snmp NMS Viewing the UPS History LogsViewing the UPS Status with CheckUPS-like Applet Receiving Event Traps Viewing UPS Monitoring ParametersAutomatic Shutdown of UPS-Protected Computers UPS Power Management Appendix Technical SpecificationsExternal BestLink Adapter Rear Panel Adapter ComponentsDIP Switch Modes DIP Switch DescriptionLED Description LED DefinitionsPin Assignments Serial Cable Definition External BestLink Adapter to UPS Serial ConnectionExternal BestLink Adapter to PC Serial Connection Upgrading the BestLink Adapter Firmware 852-2830-3030 Service and SupportExtended Service Coverage Two-Year Limited Warranty US and Canada OnlyForce Majeure International Limited WarrantyAppendix Page LTM-1343 B