Powerware IPK-0319, IPK-0320 manual Requesting a Declaration of Conformity, Class a EMC Statements

Page 2

Requesting a Declaration of Conformity

Units that are labeled with a CE mark comply with the following harmonized standards and EU directives:

:Harmonized Standards: EN 50091-1-1 and EN 50091-2; IEC 950 Second Edition, Amendments A1, A2, A3, and A4

EU Directives: 73/23/EEC, Council Directive on equipment designed for use within certain voltage limits 93/68/EEC, Amending Directive 73/23/EEC

89/336/EEC, Council Directive relating to electromagnetic compatibility 92/31/EEC, Amending Directive 89/336/EEC relating to EMC

The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC Declaration of Conformity, contact:

Powerware Corporation

Koskelontie 13

FIN-02920 Espoo

Finland

Phone: +358-9-452 661

Fax: +358-9-452 665 68

Class A EMC Statements

FCC Part 15

NOTE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

EN50091-2

Some configurations are classified under EN50091-2 as “Class-A UPS for Unrestricted Sales Distribution.” For these configurations, the following applies:

WARNING This is a Class A-UPS Product. In a domestic environment, this product may cause radio interference, in which case, the user may be required to take additional measures.

Powerware is a registered trademark and ConnectUPS, X-Slot, and BestDock are trademarks of Powerware Corporation. Netscape is a trademark of Netscape Communications Corporation. Microsoft and Windows are registered trademarks of Microsoft Corporation. Novell and NetWare are registered trademarks of Novell, Inc. UNIX is a registered trademark of The Open Group. OpenView is a trademark of Hewlett-Packard Company. NetView is a registered trademark of International Business. Machines Corporation.

Copyright 2001 Powerware Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be reproduced in any way without the express written approval of Powerware Corporation.

Image 2
Contents Bestlink SNMP/WEB Adapter FCC Part EN50091-2 Requesting a Declaration of ConformityClass a EMC Statements Page Page Table of Contents Appendix Introduction BestLink SNMP/WEB Adapter System Application Diagram System ApplicationInstallation Installing the Internal BestLink AdapterInstalling the External BestLink Adapter Installing the Internal BestLink AdapterInstalling the External BestLink Adapter Configuring the Adapter Remotely ConfigurationConfiguring the Adapter Locally Local Configuration Before You StartConnecting the BestLink SNMP/WEB Adapter Cable Connection with External BestLink AdapterBestLink SNMP/WEB Adapter Main Menu Screen Configuring the Adapter SNMP/WEB Adapter Settings ScreenExiting the Configuration Program Set SNMP/WEB Card Control Group Set Write Access ManagersSet the IP Address, Gateway Address and MIB System Group Set IP Addresses of Primary and Secondary Date Server Set UPS InformationSet Trap Receivers UPS Event ActionsBack to Main Menu Set Superuser Name and PasswordMail Notification Route add 192.168.7.18 Remote ConfigurationAdd a Routing Condition in the PC Running the Web Browser BestLink Adapter HomeSetup Network Configuration Remote Configuration Becoming a Superuser UPS Power ManagementUPS Management from a Web Browser Turning the UPS On and Off Forcing the UPS to Shut DownUPS Shutdown Schedule Configuring E-mail NotificationPlanning a Scheduled UPS Shutdown and Restart Mail NotificationSelect Battery Test Schedule Performing a Manual UPS Battery TestScheduling a UPS Battery Test Viewing the UPS Status with CheckUPS-like Applet UPS Management from an Snmp NMSViewing the UPS History Logs Viewing UPS Monitoring Parameters Receiving Event TrapsAutomatic Shutdown of UPS-Protected Computers UPS Power Management Technical Specifications AppendixAdapter Components External BestLink Adapter Rear PanelLED Description DIP Switch DescriptionDIP Switch Modes LED DefinitionsPin Assignments External BestLink Adapter to PC Serial Connection Serial Cable DefinitionExternal BestLink Adapter to UPS Serial Connection Upgrading the BestLink Adapter Firmware Service and Support 852-2830-3030Two-Year Limited Warranty US and Canada Only Extended Service CoverageInternational Limited Warranty Force MajeureAppendix Page LTM-1343 B