Powerware UPS 1000 - 2200 user manual Testing New Batteries

Page 19

4.1500 and 2200 VA units. Pull the battery out onto a flat, stable surface. Press on the black tab on the battery cable connector to disconnect the battery. See “Recycling the Used Battery” on page 20 for proper disposal.

5.Install the new batteries in the reverse order of removal.

6.Reinstall the metal battery cover removed in Step 2. Replace the front panel.

Testing New Batteries

Press and hold the button for three seconds to initiate a self–test. After the test is finished, the indicator should turn off. If the indicator stays on, check the battery connections. Call your service representative if the problem persists.

1019297

1000 - 2200 VA

19

Revision A

User’s Manual

 

Image 19
Contents UPS 1000 2200 VA User’s Manual Page Table of contents Powerware 5125 User’s Manual 1000-2200 VACopyright Class a EMC Statements VA Models Requesting a Declaration of ConformitySpecial Symbols Powerware Powerware 5125 IntroductionInstalling the UPS InstallationInspecting the Equipment UPS Rear Panels InstallationOperating Modes Operation and ConfigurationNormal Mode Standby ModeBuck and Double Boost Mode Starting the UPS on Battery Battery ModeSleep Mode UPS ConfigurationInitiating the Self-Test Turning the UPS OffCommunication Port Network Transient Protector Network Transient ProtectorVA and 1500 VA Load Segments Load SegmentsStoring the UPS and Batteries UPS MaintenanceUPS and Battery Care When to Replace BatteriesHow to Replace Extended Battery Modules Use the following procedure to replace internal batteries Testing New Batteries Recycling the Used Battery TroubleshootingAudible Alarms and UPS Conditions Alarm or Condition Possible Cause Action Silencing an Audible Alarm100% Dimensions W x D x H Weight SpecificationsBattery