Powerware UPS 1000 - 2200 user manual UPS Rear Panels, Installation

Page 9

NOTE. The batteries charge to 90% capacity in approximately 3 hours. However, it is recommended that the batteries charge for 24 hours after installation or long-term storage.

NOTE. If more than two EBMs are installed, an external battery charger is recommended for faster recharge times.

Figure 2. Installation

UPS Rear Panels

This section shows the rear panels of the Powerware 5125 models.

Figure 3. PW5125 1000i and PW5125 1500i Rear Panel

1019297

1000 - 2200 VA

9

Revision A

User’s Manual

 

Image 9
Contents UPS 1000 2200 VA User’s Manual Page Table of contents Powerware 5125 User’s Manual 1000-2200 VACopyright Class a EMC Statements VA Models Requesting a Declaration of ConformitySpecial Symbols Powerware Powerware 5125 IntroductionInstallation Installing the UPSInspecting the Equipment UPS Rear Panels InstallationOperating Modes Operation and ConfigurationStandby Mode Normal ModeBuck and Double Boost Mode Sleep Mode Battery ModeUPS Configuration Starting the UPS on BatteryTurning the UPS Off Initiating the Self-TestCommunication Port Network Transient Protector Network Transient ProtectorVA and 1500 VA Load Segments Load SegmentsUPS and Battery Care UPS MaintenanceWhen to Replace Batteries Storing the UPS and BatteriesHow to Replace Extended Battery Modules Use the following procedure to replace internal batteries Testing New Batteries Troubleshooting Recycling the Used BatteryAudible Alarms and UPS Conditions Alarm or Condition Possible Cause Action Silencing an Audible Alarm100% Dimensions W x D x H Weight SpecificationsBattery