Powerware UPS 1000 - 2200 user manual Use the following procedure to replace internal batteries

Page 18

Use the following procedure to replace internal batteries:

1.Remove the UPS front panel by pulling the top.

2.Slide up and remove the metal battery cover.

3.1000 VA units. Disconnect the red battery cable on the front of the battery. Pull the battery out onto a flat, stable surface. Disconnect the black battery cable on the rear of the battery, then on the front of the battery. Disconnect the red battery cable on the rear of the battery. See “Recycling the Used Battery” on page 20 for proper disposal.

18	1000 - 2000 VA	1019297
	User’s Manual	Revision A

Image 18

Contents UPS 1000 2200 VA User’s Manual Page Powerware 5125 User’s Manual 1000-2200 VA Table of contentsCopyright Requesting a Declaration of Conformity Class a EMC Statements VA ModelsSpecial Symbols Powerware 5125 Introduction PowerwareInstallation Installing the UPSInspecting the Equipment Installation UPS Rear PanelsOperation and Configuration Operating ModesStandby Mode Normal ModeBuck and Double Boost Mode UPS Configuration Battery ModeSleep Mode Starting the UPS on BatteryTurning the UPS Off Initiating the Self-TestCommunication Port Network Transient Protector Network Transient ProtectorLoad Segments VA and 1500 VA Load SegmentsWhen to Replace Batteries UPS MaintenanceUPS and Battery Care Storing the UPS and BatteriesHow to Replace Extended Battery Modules Use the following procedure to replace internal batteries Testing New Batteries Troubleshooting Recycling the Used BatteryAudible Alarms and UPS Conditions Silencing an Audible Alarm Alarm or Condition Possible Cause Action100% Specifications Dimensions W x D x H WeightBattery