Chapter 5: Chassis Setup and Maintenance
Chapter 5
Chassis Setup and Maintenance
5-1 Overview
This chapter covers the steps required to install components and perform mainte- nance on the chassis. The only tool you will need to install components and perform maintenance is a Phillips head screwdriver.
Read the safety warnings and installation instructions in Chapter 2 Standardized Warning Statements for AC Systems before performing setup or maintenance procedures.
5-2 Removing Power Cords
Before performing any setup or maintenance on the chassis, use the following procedure to ensure that power has been removed disconnected from the system.
Removing the Power Cord
1.Use the operating system to power down the system, following the
2.After the system has completely
3.If your system has dual redundant power supplies, remove the cords from both power supplies.
4.Disconnect the cord from the power strip or wall outlet.