SUPER MICRO Computer X9SPU-F user manual Troubleshooting Procedures, Before Power On, No Power

Chapter 3: Troubleshooting

Chapter 3

Troubleshooting

3-1 Troubleshooting Procedures

Use the following procedures to troubleshoot your system. If you have followed all of the procedures below and still need assistance, refer to the ‘Technical Support Procedures’ and/or ‘Returning Merchandise for Service’ section(s) in this chapter. Always disconnect the AC power cord before adding, changing or installing any hardware components.

Before Power On

1.Make sure that the Standby is not on. (Note: If it is on, the onboard power is on. Be sure to unplug the power cable before installing or removing the components.)

2.Make sure that there are no short circuits between the motherboard and chassis.

3.Disconnect all ribbon/wire cables from the motherboard, including those for the keyboard and mouse. Also, be sure to remove all add-on cards.

4.Install a CPU and heatsink (-be sure that it is fully seated) and then connect the chassis speaker and the power LED to the motherboard. Check all jumper settings as well.

No Power

1.Make sure that there are no short circuits between the motherboard and chassis.

2.Make sure that all jumpers are set to their default positions.

3.Check if the 115V/230V switch on the power supply is properly set.

4.Turn the power switch on and off to test the system.

5.The battery on your motherboard may be old. Check to make sure that it still supplies ~3VDC. If it does not, replace it with a new one.

3-1