SUPER MICRO Computer X9SPU-F Unit ID LED Front Panel / OH / Fan Failure, Unit ID LED Status

X9SPU-F Motherboard User’s Manual

NIC1/NIC2 (LAN1/LAN2)

The NIC (Network Interface Control- ler) LED connection for LAN port 1 is located on pins 11 and 12 of JF1, and the LED connection for LAN Port 2 is on Pins 9 and 10. NIC1 LED and NIC2 LED are 2-pin NIC LED head- ers. Attach NIC LED cables to NIC1 and NIC2 LED indicators to display network activity. Refer to the table on the right for pin definitions.

Unit ID LED (Front Panel) / OH / Fan Failure

Connect a cable to the Unit ID connec- tion on pins 7 and 8 of JF1 to connect to the Unit ID LED on the chassis. The Unit ID LED is used together with the Unit ID (UID) Switch (see 2-16). When blinking, this will also indicate that a system fan failure or overheat has been detected by the system's built-in monitors.

LAN1/LAN2 LED

Pin Definitions (JF1)

Pin# Definition

9/11 Vcc

10/12 Ground

Unit ID LED / OH / FF

Pin Definitions (JF1)

Pin# Definition

7OH/Fan Fail

8UID LED

NIC LED

Status

State	Definition
Off	No Activity
Blinking	NIC Busy

Unit ID LED

Status

State	Definition
Off	UID Off
Solid On	UID On
Blinking	System
	Overheat /
	Fan Failure

Ground

X

Power LED

HDD LED

ANIC1 LED

BNIC2 LED

CUnit ID LED Power Fail LED

Ground Ground

20 19

2 1

	A. NIC1 LED
NMI	B. NIC2 LED
X	C. UID LED
	D. Overheat / Fan Failure
Vcc
Vcc
Vcc
Vcc

OH/Fan Fail D

Vcc

#3~4 Reset Button

#1~2 Power Button

2-18