Chapter 2: Installation
Overheat (OH)/Fan Fail/PWR Fail/UID
LED
Connect an LED cable to pins 7 and 8 of JF1 to use the Overheat/Fan Fail/Power Fail and UID LED connections. The Red LED on pin 8 provides warnings of an overheat, fan failure or power failure. The Blue LED on pin 7 works as the UID LED indicator for the front panel UID switch located on pins 13~14 of JF1. When Jumper J_UID_OW is set to off (default), the Red LED takes precedence over the Blue LED. (See Page
Power Fail LED
The Power Fail LED connection is located on pins 5 and 6 of JF1. Refer to the table on the right for pin definitions.
OH/Fan Fail/ PWR Fail/Blue_UID
LEDPin Defi nitions (JF1)
Pin# Definition
7
8OH/Fan Fail/PWR Fail/UID LED (Red)
OH/Fan Fail/PWR Fail
LED Status (Red LED)
State | Indication |
Off | Normal |
|
|
On | Overheat |
|
|
Flashing | Fan Fail |
|
|
PWR Fail LED Pin Defi nitions (JF1)
Pin# Definition
53.3V
6PWR Fail LED
Reset Connector
The reset connector is located on pins 3 and 4 of JF1 and attaches to the reset switch on the computer chassis. See the table on the right for pin definitions.
Power Button
The Power Button connection is located on pins 1 and 2 of JF1. Momentarily contacting both pins will power on/off the system. This button can also be confi gured to function as a suspend button (with a setting in the BIOS - see Chapter 4). To turn off the power when set to suspend mode, press the button for at least 4 seconds. Refer to the table on the right for pin definitions.
Reset Button
Pin Definitions
(JF1)
Pin# Definition
3Reset
4Ground
Power Button
Pin Defi nitions
(JF1)
Pin# Definition
1PWR
2Ground