Chapter 5: Advanced Serverboard Setup
I2C to PCI-Express Slot
JI2C1/JI2C2 allows you to enable the I2C bus to communicate with the
Watch Dog Enable/Disable
JWD1 enables the Watch Dog function, a system monitor that takes action when a software application freezes the system. Jumping pins
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2 to enable VGA. See the table on the right for jumper settings.
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 to enable to enable or disable the LAN1 and LAN2 Ethernets ports. See the table on the right for jumper settings. The default setting is enabled.
SAS Enable/Disable
JPS1 allows you to enable or disable the SAS controller. The default position is on pins 1 and 2 to enable SAS. See the table on the right for jumper settings.
I2C to
Jumper Settings
(JI2C1/JI2C2)
Jumper Setting Definition
Closed | Enabled | |
Open | Disabled | |
|
|
Watch Dog
Jumper Settings (JWD1)
Jumper Setting Definition
Pins | Reset | |
Pins | NMI | |
Open | Disabled | |
|
|
Note: when Watch Dog is enabled, the user must write their own application software to disable the Watch Dog Timer.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Definition
Pins | Enabled | |
Pins | Disabled | |
|
|
LAN1/2 En/Disable
Jumper Settings (JPL1)
Jumper Setting Definition
Pins | Enabled | |
Pins | Disabled | |
|
|
SAS Enable/Disable
Jumper Settings (JPS1)
Jumper Setting Definition
Pins | Enabled | |
Pins | Disabled | |
|
|