SMC Networks SMC8126L2 manual Rack Mounting

Page 33

Mounting 3

Mounting

This switch can be mounted in a standard 19-inch equipment rack or on a desktop or shelf. Mounting instructions for each type of site follow.

Rack Mounting

Before rack mounting the switch, pay particular attention to the following factors:

•Temperature: Since the temperature within a rack assembly may be higher than the ambient room temperature, check that the rack-environment temperature is within the specified operating temperature range. (See page C-1.)

•Mechanical Loading: Do not place any equipment on top of a rack-mounted unit.

•Circuit Overloading: Be sure that the supply circuit to the rack assembly is not overloaded.

•Grounding: Rack-mounted equipment should be properly grounded. Particular attention should be given to supply connections other than direct connections to the mains.

To rack-mount devices:

1.Attach the brackets to the device using the screws provided in the Bracket Mounting Kit.

Figure 3-2 Attaching the Brackets

3-3

Image 33

Contents Installation Guide Page TigerSwitch 10/100/1000 Installation Guide Page Compliances and Safety Warnings N11846 Safety Compliance Power Cord Set France et Pérou uniquement Sein und die Aufschrift HAR oder Basec tragen End of Product Life Span Manufacturing MaterialsDocumentation Viii Contents Appendix C Specifications Appendix a TroubleshootingMaking Network Connections Appendix B CablesAppendix D Ordering Information Glossary Index Xii Tables Figures Overview IntroductionNetwork Management Options Switch Architecture10/100/1000BASE-T Ports Description of HardwareSFP Slots Port and System Status LEDsLED Power Supply Socket Features and BenefitsConnectivity ExpandabilityManagement Network Planning Introduction to SwitchingCollapsed Backbone Application ExamplesNetwork Aggregation Plan Network Aggregation PlanRemote Connections with Fiber Cable Remote Connections with Fiber CableMaking Vlan Connections Making Vlan Connections Application Notes Installing the Switch Selecting a SiteEthernet Cabling Equipment Checklist Package ContentsOptional Rack-Mounting Equipment Rack Mounting MountingDesktop or Shelf Mounting Installing the Switch in a RackInserting an SFP Transceiver into a Slot Installing an Optional SFP TransceiverConnecting to the Console Port Connecting to a Power SourceSerial Cable Wiring Switch’s 8-Pin Null Modem PC’s 9-Pin Wiring Map for Serial CableInstalling the Switch Making Network Connections Connecting Network DevicesTwisted-Pair Devices Cabling GuidelinesNetwork Wiring Connections Connecting to PCs, Servers, Hubs and SwitchesFiber Optic SFP Devices Network Wiring ConnectionsMaking Connections to SFP Transceivers Connectivity Rules1000BASE-T Cable Requirements Mbps Gigabit Ethernet Collision DomainMbps Fast Ethernet Collision Domain Mbps Ethernet Collision Domain Cable Labeling and Connection RecordsDiagnosing Switch Indicators Appendix a TroubleshootingPower and Cooling Problems InstallationIn-Band Access Appendix B Cables Twisted-Pair Cable and Pin Assignments10BASE-T/100BASE-TX Pin Assignments Crossover Wiring Straight-Through WiringTwisted-Pair Cable and Pin Assignments B 1000BASE-T Pin AssignmentsCable Testing for Existing Category 5 Cable Adjusting Existing Category 5 Cabling to Run 1000BASE-TFiber Standards Physical Characteristics Appendix C SpecificationsSwitch Features Management FeaturesStandards CE Mark CompliancesSpecifications Appendix D Ordering Information Ordering Information Glossary Ethernet End StationFast Ethernet Full DuplexRedundant Power Supply RPS Media Access Control MACRJ-45 Connector Switched PortsVirtual LAN Vlan Transmission Control Protocol/Internet Protocol TCP/IPNumerics IndexIndex Page Technical Support