SMC Networks SMCWTK-G manual Compliances, Federal Communication Commission Interference Statement

Page 3

Compliances

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

zReorient or relocate the receiving antenna.

zIncrease the separation between the equipment and receiver.

zConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.

zConsult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, (example – use only shielded interface cables when connecting to computer or peripheral devices). Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Industry Canada - Class B

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus,” ICES-003 of Industry Canada.

Cet appareil numerique respecte les limites de bruits radioelectriques applicables aux appareils umeriques de Classe B prescrites dans la norme sur le material brouilleur: “Appareils Numeriques,” NMB-003 edictee par l’Industrie.

Image 3
Contents Page Trademarks CopyrightIndustry Canada Class B CompliancesFederal Communication Commission Interference Statement FCC Radiation Exposure StatementIntended for use in the following countries EC Conformance DeclarationWichtige Sicherheitshinweise Germany Introduction EZ Connect g 2.4GHz 802.11g Wireless Traveler’s KitFeatures Package ContentsSystem Requirements Page Using the EZ Installation Wizard Page Page Page Page Page Page SMCWTK-G is now ready to use Operating Modes Introduction to Operating Modes Traveler’s AP ModeOne Wireless Repeater Node Repeater ModeP2P Wireless Bridge Point-to-Point P2P ModePMP Wireless Bridge Point-to-Multipoint PMP ModeClient in Infrastructure Mode Client ModeWireless Security Support Wireless Security ModeComments Mode Mode SelectionBasic Setup AP SetupAP Setup Field Description Security SetupWEP Configuration WPA Configuration WEP Setup Field DescriptionWPA Setup Field Description Advanced Settings Advanced SettingsAccess Filter AP Advanced Settings Field DescriptionAdding a Repeater Access Filter Settings AP Access Filter Settings Field Description Repeater Setup Repeater SetupRepeater Setup Field Description Repeater Advanced Settings Field Description Repeater Access Filter Settings Field Description P2P Setup Point-to-Point P2P SetupP2P Advanced Settings Field Description PMP Setup Point-to-Multipoint PMP SetupPMP Setup Field Description PMP Advanced Settings Field Description Client Bridge Setup Client Mode SetupField Description MAC CloningStatus StatusReboot AdminFirmware Upgrade Update PasswordReset to Default Setting LAN LAN Configuration Utility Scan/Configuration UtilityTelnet Step-by-Step Telnet ManagementCommand Reference Table Get site Product Specifications Operating Temperature Management and ConfigurationOperation Mode DC Power AdapterSize WeightFor Technical SUPPORT, Call