SMC Networks SMC2755W manual Transmit Threshold

Page 28

EZ CONNECT™ 802.11A WIRELESS ACCESS POINT

The DTIM is the interval between two synchronous frames with broadcast information. If you set the value to 2, the access point will save all multicast frames for the BSS and forward them after every second beacon. Having smaller DTIM intervals delivers multicast frames in a more timely manner, causing stations in Power Save mode to wake up more often and drain power faster. Having higher DTIM values, though, delays the transmission of multicast frames.

(Default: 1)

Transmit Threshold

Fragment Length (256-2346): The “Fragment Length” can be set between 256 and 2,346. If the packet size is smaller than the preset Fragment size, the packet will not be segmented.

Fragmentation of the PDUs can increase the reliability of transmission because it increases the probability of a successful transmission due to smaller frame size. If there is significant interference present or collisions due to high network utilization, try setting the fragment size to send smaller fragments. This will enable the retransmission of smaller frames much faster. However, it is more efficient to set the fragment size larger if very little or no interference is present because it requires overhead to send multiple frames. (Default: 2346)

20

Image 28
Contents EZ ConnectTM Page EZ ConnectTM User Guide Copyright TrademarksLimited Warranty Limited Warranty FCC Class B CompliancesIndustry Canada Class B Compliances EZ Connect 802.11A Wireless Access Point Package ChecklistHardware Description Radio CharacteristicsEthernet Compatibility Applications Frequently changing environmentsLED Indicators LEDSystem Requirements Hardware Installation SMC2755W Top PanelSMC2755W Rear Panel System Configuration Windows Installation 98/2000/Me/NT/XP Setup Wizard System Configuration EZ Connect 802.11A Wireless Access Point Standard WEP Setup screen. Default Open System Bit Manual Entry Advanced Setup Identification Channel Performance Synchronization Transmit Threshold TCP / IP Settings Page Authentication Type EncryptionAdvanced WEP Setup Using MAC Filter Change Password SystemUpgrade Firmware Factory DefaultStatus Access Point Status AP ConfigurationAP SME Station Management Entity Connected Station StatusAP Statistics Station Configuration Station SME Station Statistics Network Configuration and Planning Ad-hoc Wireless LAN no AP or Bridge Network TopologiesInfrastructure Wireless LAN Infrastructure Wireless LAN for Roaming Wireless PCs Troubleshooting Limited-lifetime warranty Important NoticeSpecifications Sensitivity Modulation/Rates Sensitivity dBmModulation Modulation 15-5.25GHZ 25-5.35GHZ DBmPower supply Output PowerWeight LED IndicatorsSafety WarrantyEmissions StandardsTerminology EZ Connect 802.11A Wireless Access Point Page For Technical SUPPORT, Call