SMC Networks SMC8014W-G manual Routing, Pptp IP Address Pool, Adding Static Routes

NOTE: You cannot use the IP address of the Gateway (192.168.0.1 – default IP) in the client address pool.

PPTP IP Address Pool

When the Gateway is configured to act as a PPTP VPN server in the VPN Settings section, PPTP clients will be assigned IP addresses in this range for their PPTP WAN interface.

ROUTING

From this section you can configure Static Routes and RIP Control settings.

Static Routes

Use this section to configure Static Routes on your network. A static route setting will allow you to configure a different Gateway for a Specific Destination IP.

To access the Static Routes configuration page, on the Side Navigation bar, click on the [WAN] link and then select the [Static Route] link.

NOTE: Users cannot add any static routes to a public network assigned by your cable operator. Users can add other private networks that are located on the LAN side of the SMC8014W-G.

Adding Static Routes

The screen shot below shows the Configuration Page for adding a Static Route to your network. To access this screen, click on the [Add] button from the main [Static Routes] page (shown above).