SMC Networks SMC8014W-G manual Appendix a Telnet and SSH CLI Commands

APPENDIX A Telnet and SSH CLI Commands

Refer to the Remote Management section in Chapter 6 to enable and configure Telnet and SSH settings.

Refer to the 8014 CLI document for command specifics.

To remotely access the CLI of the SMC8014W-G via Telnet, open a DOS/Command Prompt and type: telnet IP remote mgmt port Enter

•NOTE: Telnet remote management is not enabled by default. To enable, first log into the Gateway via the HTTP web admin page and go to System/Remote Management and select the check box next to Telnet Port

•For example, open a command prompt and type: telnet xxx.xxx.xxx.xxx 2323 Enter (where xxx.xxx.xxx.xxx is your WAN IP listed on the status page)

•Enter the same user and password as used for the GUI/HTTP

•Commands are case sensitive

•Type help and then Enter for a list of commands

Use an SSH client of your choice for SSH remote management.