Seagate ST9200011FS Configuring and mounting the drive, Handling and static-discharge precautions

Page 25

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static-discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

Handle the drive by its edges or frame only.

The drive is fragile—handle it with care. Do not press down on the drive top cover.

Always rest the drive on a padded, antistatic surface until you mount it in the computer.

Do not touch the connector pins or the printed circuit board.

Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive.

Pulsar Product Manual, Rev. A

19

Image 25
Contents ST9200011FS ST9100011FS ST950011FS PulsarTMRevision Date Revision historyContents Pulsar Product Manual, Rev. a List of Figures Page Introduction About the Serial ATA interface Drive specifications summary for 200, 100 and 50 GB models Specification summary tablesPulsar Product Manual, Rev. a Formatted capacity Default logical geometry for ATA based systemsPerformance, Recording and interface technology Performance Physical characteristicsTypical access times µs Read Write Access timeTime to Ready Power specifications 200GB DC power requirements 100GB DC power requirements 50GB DC power requirements Conducted noise Typical current profilesVoltage tolerance Environmental specifications Vibration Electromagnetic immunityOperating vibration Nonoperating vibrationReliability Reliability specificationsAgency certification Chassis Environmental protectionCorrosive environment Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensions-top, side and end viewAir flow CoolingHot-Plug compatibility Serial ATA Sata interfaceSerial ATA connector pin definitions Serial ATA device plug connector pin definitionsSignal Pin Function DefinitionSupported ATA commands Supported ATA commandsCommand name Command code in hex C6H Word Description Value Identify Device commandXxxxh Ffffh Bit Word Description if bit is set to Bit WordDevice supports Software Settings Preservation Media serial number is supported Write-Read-Verify feature set is supported Set Features command values Set Features commandA.R.T. commands 3 S.M.A.R.T. commandsCode in features register A.R.T. command Pulsar Product Manual, Rev. a Web Warranty Support Direct.seagate.com Spp.seagate.comData Recovery Services Authorized Service Centers Technical Support Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Presales SupportIndex Page Page Pulsar Product Manual, Rev. a Page Disc Drive, Scotts Valley, California 95066-4544, USA