Seagate ST9200011FS, ST950011FS, ST9100011FS manual Introduction

Page 7

1.0Introduction

This manual describes the functional, mechanical and interface specifications for the following Seagate PulsarTM model drives:

ST9200011FS ST9100011FS ST950011FS

These drives provide the following key features:

•Single Layer Cell (SLC) NAND Flash storage.

•High instantaneous (burst) data-transfer rates (up to 300MB/s).

•Parallel flash access channels.

•State-of-the-art on-the-fly error-correction algorithms.

•Native Command Queueing with command ordering to increase performance in demanding applications.

•Highly integrated hardware functions.

•Power loss data protection.

•Data Set Management with Trim Support.

•Silent operation.

•SeaTools diagnostic software performs a drive self-test that eliminates unnecessary drive returns.

•Support for S.M.A.R.T. drive monitoring and reporting.

•Supports latching SATA cables and connectors.

•Worldwide Name (WWN) capability uniquely identifies the drive.

Pulsar Product Manual, Rev. A

1

Image 7

Contents ST9200011FS ST9100011FS ST950011FS PulsarTMRevision Date Revision historyContents Pulsar Product Manual, Rev. a List of Figures Page Introduction About the Serial ATA interface Drive specifications summary for 200, 100 and 50 GB models Specification summary tablesPulsar Product Manual, Rev. a Formatted capacity Default logical geometry for ATA based systemsPerformance, Recording and interface technology Performance Physical characteristicsTypical access times µs Read Write Access timeTime to Ready Power specifications 200GB DC power requirements 100GB DC power requirements 50GB DC power requirements Conducted noise Typical current profilesVoltage tolerance Environmental specifications Nonoperating vibration Electromagnetic immunityVibration Operating vibrationReliability Reliability specificationsAgency certification Chassis Environmental protectionCorrosive environment Handling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensions-top, side and end viewAir flow CoolingHot-Plug compatibility Serial ATA Sata interfacePin Function Definition Serial ATA device plug connector pin definitionsSerial ATA connector pin definitions SignalSupported ATA commands Supported ATA commandsCommand name Command code in hex C6H Word Description Value Identify Device commandXxxxh Ffffh Bit Word Description if bit is set to Bit WordDevice supports Software Settings Preservation Media serial number is supported Write-Read-Verify feature set is supported Set Features command values Set Features commandA.R.T. commands 3 S.M.A.R.T. commandsCode in features register A.R.T. command Pulsar Product Manual, Rev. a Web Warranty Support Direct.seagate.com Spp.seagate.comPresales Support Technical Support Warranty ServiceData Recovery Services Authorized Service Centers Data Recovery Services Call Center Toll-free Direct dialIndex Page Page Pulsar Product Manual, Rev. a Page Disc Drive, Scotts Valley, California 95066-4544, USA