Seagate ST3450856SS, ST3146356SS, ST3300656SS manual Environmental limits, Temperature

Page 38

6.4Environmental limits

Temperature and humidity values experienced by the drive must be such that condensation does not occur on any drive part. Altitude and atmospheric pressure specifications are referenced to a standard day at 58.7°F (14.8°C). Maximum wet bulb temperature is 82°F (28°C).

6.4.1Temperature

a. Operating

The maximum allowable continuous or sustained HDA case temperature for the rated Annualized Failure Rate (AFR) is 122°F (50°C) The maximum allowable HDA case temperature is 60°C. Occasional excur- sions of HDA case temperatures above 122°F (50°C) or below 41°F (5°C) may occur without impact to the specified AFR. Continual or sustained operation at HDA case temperatures outside these limits may degrade AFR.

Provided the HDA case temperatures limits are met, the drive meets all specifications over a 41°F to 131°F (5°C to 55°C) drive ambient temperature range with a maximum temperature gradient of 36°F (20°C) per hour. Air flow may be needed in the drive enclosure to keep within this range (see Section 8.3). Operation at HDA case temperatures outside this range may adversely affect the drives ability to meet specifications. To confirm that the required cooling for the electronics and HDA case is provided, place the drive in its final mechanical configuration, perform random write/read operations and measure the HDA case temperature after it has stabilized.

b.Non-operating

–40° to 158°F (–40° to 70°C) package ambient with a maximum gradient of 36°F (20°C) per hour. This specification assumes that the drive is packaged in the shipping container designed by Seagate for use with drive.

HDA Temp. Check Point

1.0"

.5"

Figure 8. Location of the HDA temperature check point

32	Cheetah 15K.6 SAS Product Manual, Rev. A

Image 38

Contents Cheetah 15K.6 SAS ST3450856SS ST3300656SS ST3146356SSPage Contents Seagate Technology support services Defect and error managementInstallation Interface requirementsList of Figures Cheetah 15K.6 SAS disk driveCheetah 15K.6 SAS Product Manual, Rev. a Scope Cheetah 15K.6 SAS disk driveCheetah 15K.6 SAS Product Manual, Rev. a Electromagnetic compatibility Standards, compliance and reference documentsStandards Electromagnetic susceptibilityCompliance European Union Restriction of Hazardous Substances RoHSReference documents Cheetah 15K.6 SAS Product Manual, Rev. a General description Performance Standard featuresMedia description Reliability Factory-installed accessoriesOptions factory installed Formatted capacitiesCheetah 15K.6 SAS Product Manual, Rev. a Access time Performance characteristicsInternal drive characteristics Seek timeStart/stop time Format command execution time minutesGeneral performance characteristics Prefetch/multi-segmented cache control Cache operationCaching write data Prefetch operationRecoverable Errors Reliability specificationsError rates Unrecoverable ErrorsInterface errors Reliability and serviceSeek errors Preventive maintenancePerformance impact 4 S.M.A.R.TControlling S.M.A.R.T MillisecondsPredictive failures Reporting controlDetermining rate Thermal monitorReference Temperature Temperature Log Page 0DhPrimary Temperature Parameter Code DescriptionShort and extended tests State of the drive prior to testingInvoking DST Short test Function Code 001bShipping Product warrantyAbort Product repair and return informationCheetah 15K.6 SAS Product Manual, Rev. a DC power requirements Physical/electrical specificationsAC power requirements ST3450856SS DC power requirementsST3300656SS Gbit mode Amps ST3300656SS DC power requirementsST3146356SS DC power requirements ST3146356SS Gbit mode AmpsConducted noise immunity General DC power requirement notesPower sequencing Current profilesTypical ST3450856SS current profiles Typical ST3300656SS current profiles Typical ST3146356SS current profiles Power dissipation ST3450856SS in 3 Gbit operationST3300656SS CURRENT/POWER vs Throughput SAS 3.0GB ST3300656SS in 3 Gbit operationRandom 8 Block Reads ST3146356SS CURRENT/POWER vs Throughput SAS 3.0GBST3146356SS in 3 Gbit operation Temperature Environmental limitsShock and vibration Relative humidityEffective altitude sea level ShockPackage size Packaged/product weight Drop height Recommended mountingAcoustics Air cleanlinessVibration Corrosive environmentMechanical specifications Physical dimensions Cheetah 15K.6 SAS Product Manual, Rev. a Drive error recovery procedures Defect and error managementDrive internal defects/errors 51.87 Media Pre-Scan SAS system errorsBackground Media Scan Deferred Auto-Reallocation Idle Read After WriteInstallation Drive orientationCooling Air flowDrive mounting GroundingCheetah 15K.6 SAS Product Manual, Rev. a SAS features Interface requirementsDual port support Command name Command code Supported Scsi commands supportedCommands supported by Cheetah 15K.6 SAS family drives Commands supported by Cheetah 15K.6 SAS family drives Commands supported by Cheetah 15K.6 SAS family drives Commands supported by Cheetah 15K.6 SAS family drives Bytes Data hex Mode Sense dataInquiry data Page 2.1 ST3450856SS Mode Sense data Mode Pages2.2 ST3300656SS Mode Sense data 2.3 ST3146356SS Mode Sense data Supported Feature or condition Miscellaneous operating features and conditionsMiscellaneous features Miscellaneous statusSAS physical interface Datum B Physical characteristics Connector requirementsPin descriptions Pin Signal name Signal typeElectrical description SAS pin descriptionsSAS transmitters and receivers Signal characteristicsPower Ready LED OutGeneral interface characteristics LED drive signalDifferential signals Eye masks Eye masks overviewAbsolute amplitude Receive eye maskJitter tolerance masks Normalized time in UIJitter Peak-toSinusoidal Frequency in kHzTransmitter signal characteristics Signal characteristica Units GbpsMaximum allowable jitter Receiver signal characteristicsSignal characteristic Units Gbps Gbps m, n Deterministic jitterqCompliant jitter test pattern Cjtpat Impedance specificationsReceiver jitter tolerance Impedance requirements Sheet 1Electrical TxRx connections Transmitter characteristicsImpedance requirements Sheet 2 = -5,437dB Shows the zero-length test load Receiver characteristics Cheetah 15K.6 SAS Product Manual, Rev. a Presales Support Seagate Technology support servicesInternet Technical SupportData Recovery Services Call Center Toll-free Direct dial Warranty ServiceData Recovery Services Authorized Service Centers Index NumericsPage SAS See also cooling