Seagate ST3300656SS manual Transmitter signal characteristics, Signal characteristica Units Gbps

Page 73

9.5.2.2Transmitter signal characteristics

Table 16 specifies the signal requirements at the transmitter end of a TxRx connection as measured into the zero-length test load. All specifications are based on differential measurements.

The OOB sequence is performed at signal voltage levels corresponding to the lowest supported transfer rate. Table 16 specifies the signal characteristics.

Table 16: Transmitter signal characteristics

Signal characteristica

Units

1.5 Gbps

3.0 Gbps

Skewb

ps

20

15

Tx Off Voltagec

mV(P-P)

< 50

< 50

Maximum rise/fall timed

ps

273

137

Minimum rise/fall timed

ps

67

67

Maximum transmitter output imbalancee

%

10

10

OOB offset deltaf

mV

± 25

± 25

OOB common mode deltag

mV

± 50

± 50

aAll tests in this table shall be performed with zero-length test load shown in figure 21.

bThe skew measurement shall be made at the midpoint of the transition with a repeating 0101b pattern on the physical link. The same stable trigger, coherent to the data stream, shall be used for both the Tx+ and Tx- signals. Skew is defined as the time difference between the means of the midpoint crossing times of the Tx+ signal and the Tx- signal.

cThe transmitter off voltage is the maximum A.C. voltage measured at compliance points when the transmitter is unpowered or transmitting D.C. idle (e.g., during idle time of an OOB signal).

dRise/fall times are measured from 20 % to 80 % of the transition with a repeating 0101b pattern on the physical link.

eThe maximum difference between the V+ and V- A.C. RMS transmitter amplitudes measured on a CJTPAT test pattern (see 9.5.2.3.3) into the test load shown in figure 21, as a percentage of the average of the V+ and V- A.C. RMS amplitudes.

fThe maximum difference in the average differential voltage (D.C. offset) component between the burst times and the idle times of an OOB signal.

gThe maximum difference in the average of the common mode voltage between the burst times and the idle times of an OOB signal.

Cheetah 15K.6 SAS Product Manual, Rev. A

67

Image 73
Contents ST3450856SS ST3300656SS ST3146356SS Cheetah 15K.6 SASPage Contents Installation Defect and error managementSeagate Technology support services Interface requirementsCheetah 15K.6 SAS disk drive List of FiguresCheetah 15K.6 SAS Product Manual, Rev. a Cheetah 15K.6 SAS disk drive ScopeCheetah 15K.6 SAS Product Manual, Rev. a Standards Standards, compliance and reference documentsElectromagnetic compatibility Electromagnetic susceptibilityEuropean Union Restriction of Hazardous Substances RoHS ComplianceReference documents Cheetah 15K.6 SAS Product Manual, Rev. a General description Media description Standard featuresPerformance Options factory installed Factory-installed accessoriesReliability Formatted capacitiesCheetah 15K.6 SAS Product Manual, Rev. a Internal drive characteristics Performance characteristicsAccess time Seek timeGeneral performance characteristics Format command execution time minutesStart/stop time Cache operation Prefetch/multi-segmented cache controlPrefetch operation Caching write dataError rates Reliability specificationsRecoverable Errors Unrecoverable ErrorsSeek errors Reliability and serviceInterface errors Preventive maintenanceControlling S.M.A.R.T 4 S.M.A.R.TPerformance impact MillisecondsDetermining rate Reporting controlPredictive failures Thermal monitorPrimary Temperature Temperature Log Page 0DhReference Temperature Parameter Code DescriptionInvoking DST State of the drive prior to testingShort and extended tests Short test Function Code 001bAbort Product warrantyShipping Product repair and return informationCheetah 15K.6 SAS Product Manual, Rev. a AC power requirements Physical/electrical specificationsDC power requirements ST3450856SS DC power requirementsST3146356SS DC power requirements ST3300656SS DC power requirementsST3300656SS Gbit mode Amps ST3146356SS Gbit mode AmpsPower sequencing General DC power requirement notesConducted noise immunity Current profilesTypical ST3450856SS current profiles Typical ST3300656SS current profiles Typical ST3146356SS current profiles ST3450856SS in 3 Gbit operation Power dissipationST3300656SS in 3 Gbit operation ST3300656SS CURRENT/POWER vs Throughput SAS 3.0GBST3146356SS in 3 Gbit operation ST3146356SS CURRENT/POWER vs Throughput SAS 3.0GBRandom 8 Block Reads Environmental limits TemperatureEffective altitude sea level Relative humidityShock and vibration ShockRecommended mounting Package size Packaged/product weight Drop heightVibration Air cleanlinessAcoustics Corrosive environmentMechanical specifications Physical dimensions Cheetah 15K.6 SAS Product Manual, Rev. a Drive internal defects/errors Defect and error managementDrive error recovery procedures 51.87 Background Media Scan SAS system errorsMedia Pre-Scan Idle Read After Write Deferred Auto-ReallocationDrive orientation InstallationAir flow CoolingGrounding Drive mountingCheetah 15K.6 SAS Product Manual, Rev. a Interface requirements SAS featuresDual port support Commands supported by Cheetah 15K.6 SAS family drives Scsi commands supportedCommand name Command code Supported Commands supported by Cheetah 15K.6 SAS family drives Commands supported by Cheetah 15K.6 SAS family drives Commands supported by Cheetah 15K.6 SAS family drives Inquiry data Mode Sense dataBytes Data hex Page Mode Pages 2.1 ST3450856SS Mode Sense data2.2 ST3300656SS Mode Sense data 2.3 ST3146356SS Mode Sense data Miscellaneous features Miscellaneous operating features and conditionsSupported Feature or condition Miscellaneous statusSAS physical interface Datum B Connector requirements Physical characteristicsElectrical description Pin Signal name Signal typePin descriptions SAS pin descriptionsPower Signal characteristicsSAS transmitters and receivers Ready LED OutDifferential signals LED drive signalGeneral interface characteristics Eye masks Eye masks overviewJitter tolerance masks Receive eye maskAbsolute amplitude Normalized time in UISinusoidal Peak-toJitter Frequency in kHzSignal characteristica Units Gbps Transmitter signal characteristicsSignal characteristic Units Gbps Receiver signal characteristicsMaximum allowable jitter Gbps m, n Deterministic jitterqReceiver jitter tolerance Impedance specificationsCompliant jitter test pattern Cjtpat Impedance requirements Sheet 1Impedance requirements Sheet 2 Transmitter characteristicsElectrical TxRx connections = -5,437dB Shows the zero-length test load Receiver characteristics Cheetah 15K.6 SAS Product Manual, Rev. a Internet Seagate Technology support servicesPresales Support Technical SupportData Recovery Services Authorized Service Centers Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Numerics IndexPage SAS See also cooling