Western Telematic PLS-345 manual Command Summary, Display Commands, Display Help Screen

Page 49

10. Command Summary

All PLS-345 commands conform to the following standards:

All commands normally begin with the "/" (foreword slash) character. If you wish to temporarily suppress command echo, use the "\" (backward slash) character instead of a forward slash.

All command lines are invoked by pressing the [Enter] key.

Both the System Level Password and User Level Password are case sensitive.

10.1. Display Commands

These commands are used to display the help screen, circuit status and network status.

/H Display Help Screen

Displays a Help Screen (Figure 3.2), which lists all available commands, along with a brief description of each command.

Command Format: /H [Enter]

Response: Displays Command Help Screen, followed by the PLS> command prompt.

Command Availability: System and User.

/S Display Circuit Status

Displays a status screen (Figure 3.1), which lists the currently selected A/B line for each of the three circuits, and the selected values for features such as the Command Echo and Inactivity Timeout.

Command Format: /S [Enter]

Response: Displays Circuit Status Screen, followed by the PLS> command prompt.

Command Availability: System and User.

10-1

Image 49

Contents PLS-345 Page Shock Hazard Do Not Enter Nameplate Power WarningVentilation Enclosed RacksTable of Contents Application Examples Command SummaryIntroduction Monitor ModeApplications Typographic ConventionsFront Panel Unit DescriptionBack Panel Back PanelUnit Description PLS-345 Physical Layer Switch Users Guide Quick Start / System Overview $ telnet 192.168.168.168 Enter Modem & Console Port Access Factory set PLSCircuit Status Screen Command Help Screen System Mode Power Supply Connection InstallationInitialization Connecting the Network Cable Connecting Common and A/B LinesConnecting an External Modem Connecting a PC to the Console PortSystem Mode and User Mode SetUp and ConfigurationCommunicating with the PLS-345 SetUp and Configuration PLS Command/Menu Conventions Defining General Parameters SetUp and ConfigurationPLS-345 Physical Layer Switch Users Guide SetUp and Configuration Circuit Parameters Menu Circuit ParametersNetwork Parameters Network Parameters Menu IP Security Implementing IP SecurityExample 1 Deny access to all hosts except Hardware Configuration Monitor ModeSelecting Monitor Mode Parameters Monitor Mode Parameters Menu Switch if Level 1 High Switch to Position B Return On Save Configuration Parameters Circuit Status Screen Status ScreensPLS-345 Physical Layer Switch Users Guide Port Network Status ScreenPLS-345 Physical Layer Switch Users Guide Operation Manual A/B Switching/A Command and the /B Command Code Activated A/B SwitchingEnter or /B n Enter EnterCommand Confirmation Prompt /D CommandMonitor Mode Sending Parameters to a File Saving and Restoring Configuration ParametersRestoring Saved Parameters Application Examples Monitoring Signal Drop and/or Power Loss AUX Port Connection Monitoring a Contact Monitoring a Switch or RelayItem 6 Circuits to Switch Enable the Monitor Mode at circuit Display Commands Command SummaryDisplay Help Screen Display Circuit StatusSN Display Network Status Configuration CommandsView/Set General Parameters View/Set Circuit ParametersDL Download Configuration to File View/Set Monitor Mode ParametersView/Set Network Parameters Switch Circuit n to Line a Control CommandsSwitch Circuit n to Line B Reset Network Interface Set Circuits to DefaultCommand Format /D Enter Command Arguments Command Format /T Enter Command ArgumentsExit/Disconnect Command Format /X Enter Command ArgumentsConsole Port Interface Interface DescriptionsModem Port Interface Figure A.3 Common Ports and A/B Ports Common Ports and A/B PortsSwitching SpecificationsSize Trademark and Copyright Information Customer ServiceIndex Index-2 Page Sterling Irvine California 949 586-9950 Toll Free